AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Improved surface integrity in Inconel 718 using small diameter hammer peening tools

Aitor MADARIAGAa( ), Gorka ORTIZ-DE-ZARATEb, Pedro José ARRAZOLAb
Department of Materials, University of Manchester, Manchester M13 9PL, United Kingdom
Mechanical and Industrial Production Department, Faculty of Engineering, Mondragon Unibertsitatea, Arrasate 20500, Spain

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

Machine Hammer Peening (MHP) is an emergent treatment that induces high compressive Residual Stresses (RS) which can enhance the in-service performance of components. This paper studies the use of small diameter MHP tools to improve the Surface Integrity (SI) of the nickel-based alloy Inconel 718 used in critical aero-engine components. Complementarily, the relaxation of RS is analyzed by in-situ annealing tests at in-service temperature combined with X-ray diffraction measurement. For this purpose, age hardened Inconel 718 discs were turned as reference condition, and then a pneumatic MHP tool was used under different conditions: two tool diameters (4 mm and 12 mm), feed rates (2.5 m/min and 5.0 m/min) and stepover distances (0.07 mm and 0.35 mm). Subsequently, surface topography characterization, RS measurements, nanoindentation tests, and microstructural observations were conducted. The in-situ annealing tests were done in the X-ray diffractometer at 550 °C for exposure periods from 0 to 20 h. The results demonstrate that 4 mm diameter tools generate smooth surfaces and induce significant compressive RS within a 0.5 mm thick layer. Residual stresses are relaxed, but they remain compressive even after a long thermal exposure. The microstructure of the surface layer (<10–15 μm) was affected by the preceding turning operation, but importantly, MHP did not induce additional damage.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
MADARIAGA A, ORTIZ-DE-ZARATE G, ARRAZOLA PJ. Improved surface integrity in Inconel 718 using small diameter hammer peening tools. Chinese Journal of Aeronautics, 2025, 38(7). https://doi.org/10.1016/j.cja.2025.103554

2

Views

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 13 May 2024
Revised: 26 June 2024
Accepted: 31 July 2024
Published: 25 April 2025
© 2025 The Author(s). Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY license (http://creativecommons.org/licenses/by/4.0/).