AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Enhanced quasi-three-dimensional transient simulation technique incorporating component volume effects for aero engine

Yuchen DAIa, Manxiang SONGa, Donghai JINa,b( ), Xingmin GUIa,b
Aeroengine Simulation Research Center, School of Energy and Power Engineering, Beihang University, Beijing 100191, China
Jiangxi Research Institute of Beihang University, Nanchang 330096, China

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

Current transient analysis predominantly relies on zero-dimensional/one-dimensional tools, proficient at capturing aerothermodynamic variations across critical engine stations but insufficient for analyzing the internal flow field evolution during transients. Addressing this gap, the study presents an enhanced quasi-three dimensional (quasi-3D) transient simulation technique that integrates component volume effects, offering a significant leap from the preceding quasi-3D transient simulation method based on quasi-steady assumption. By embedding the component volume effects on density, momentum, and energy within the physical temporal dimension of the Navier-Stokes equations, the refined quasi-3D transient model achieves a closer representation of physical phenomena. Validation against a single-shaft turbofan engine’s experimental data confirms the model’s accuracy. Average errors for key performance indicators, including shaft speed, thrust, mass flow rate, and critical component exit temperature and pressure, remain below 0.41%, 5.69%, 2.55%, 3.18% and 0.67%, respectively. Crucially, the model exposes a discernible temporal lag in the compressor outlet pressure and temperature response due to volume effects—previously unquantified in quasi-3D transient simulations. And further exploration of the meridional flow field emphasizes the consequential role of volumes in transient flow field evolution. Incorporating volume effects within quasi-3D transient simulations enhances engine modeling and is pivotal for precise transient analysis in engine design and optimization.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 325-346

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
DAI Y, SONG M, JIN D, et al. Enhanced quasi-three-dimensional transient simulation technique incorporating component volume effects for aero engine. Chinese Journal of Aeronautics, 2024, 37(12): 325-346. https://doi.org/10.1016/j.cja.2024.07.020

893

Views

6

Crossref

5

Web of Science

5

Scopus

0

CSCD

Received: 26 December 2023
Revised: 20 February 2024
Accepted: 30 April 2024
Published: 20 July 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).