AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

A three-dimensional inverse method based on moving no-slip boundary for profiled end wall design

Hanwen GUOa, Donghai JINa,b( ), Jiancheng ZHANGa, Xingmin GUIa,b
School of Energy and Power Engineering, Beihang University, Beijing 100191, China
Jiangxi Research Institute of Beihang University, Nanchang 330096, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

How to utilize existing flow control mechanisms to make profiled end wall design more flexible, efficient, and physical is a meaningful challenge. This study presents a three-dimensional inverse method for profiled end wall design to achieve the application of flow control mechanisms. The predetermined pressure distribution on the end wall is reached by modifying the end wall geometry during flow field calculation. A motion velocity model is derived from the normal momentum equation of the moving no-slip boundary to modify the end wall geometry. A Reynolds-Averaged Navier-Stokes (RANS) solver based on the Semi-Implicit Method for Pressure Linked Equations (SIMPLE) algorithm is adopted to simulate the flow field. Based on the mechanism understanding obtained through numerical optimization results, this study adopts the inverse method to redesign an optimized end wall in a compressor cascade. The results indicate that the redesigned end wall exhibits better loss reduction, reducing the overall total pressure loss by 5.5%, whereas the optimized end wall reduces it by 3%. The inverse method allows the imposition of desired influences on the end wall flow without constructing a database, making it highly flexible, efficient, and physical.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 221-233

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
GUO H, JIN D, ZHANG J, et al. A three-dimensional inverse method based on moving no-slip boundary for profiled end wall design. Chinese Journal of Aeronautics, 2024, 37(10): 221-233. https://doi.org/10.1016/j.cja.2024.06.001

752

Views

4

Crossref

3

Web of Science

4

Scopus

1

CSCD

Received: 18 October 2023
Revised: 12 November 2023
Accepted: 27 December 2023
Published: 06 June 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).