AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Large eddy simulation of boundary layer combustion of hydrogen and hydrocarbon fuel films in a modeled scramjet combustor

Jianfei WEI, Silong ZHANG( ), Jingying ZUO, Xin LI, Jiang QIN, Wen BAO
School of Energy Science and Engineering, Harbin Institute of Technology, Harbin 150001, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Supersonic fuel film cooling is a promising way to simultaneously reduce the severe wall heat and friction load of the internal passage in a scramjet engine when operating at hypersonic conditions. Large eddy simulations were performed to investigate the cooling and wall friction characteristics of hydrogen and hydrocarbon films under inert and reactive circumstances. The results show that the essential difference of the turbulent state in the mixing layer contributes to the totally different behaviors of the cooling and wall friction reduction performances of the two fuel films. The turbulent transport processes between the hydrogen film and the mainstream are much weaker as compared to the case of hydrocarbon film, making inert hydrogen rather superior in cooling and friction reduction applications. Besides, the increase of wall temperature for hydrogen film under the inert case is mainly driven by the loss of hydrogen with high heat capacity instead of by direct heat addition. However, the film cooling performance severely deteriorates when the hydrogen film burns due to presence of severe heat release sources near the wall. On the other hand, combustion of hydrocarbon film in the boundary layer can remarkably improve its originally barely-satisfactory cooling and friction reduction performance to the level comparable to that of hydrogen film, due to the suppression of turbulent transport processes in the mixing layer and presence of heat absorption sources near the wall. Overall, the hydrogen film is more advantageous in friction reduction, while the hydrocarbon film is more suitable for cooling.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 109-133

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
WEI J, ZHANG S, ZUO J, et al. Large eddy simulation of boundary layer combustion of hydrogen and hydrocarbon fuel films in a modeled scramjet combustor. Chinese Journal of Aeronautics, 2024, 37(7): 109-133. https://doi.org/10.1016/j.cja.2024.04.023

1118

Views

14

Crossref

14

Web of Science

13

Scopus

1

CSCD

Received: 18 July 2023
Revised: 11 September 2023
Accepted: 29 October 2023
Published: 29 April 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).