AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Thermal oxidation description methodology of thermal barrier coatings on gas turbine blades considering service characteristics

Qiannan TAOa, Yanrong WANGa,b, Dasheng WEIa,b, Shun YANGa( )
School of Energy and Power Engineering, Beihang University, Beijing 100191, China
Jiangxi Research Institute of Beihang University, Nanchang 330096, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Predicting the thickness of Thermally Grown Oxide (TGO) and the residual stresses induced by TGO growth in the Thermal Barrier Coatings (TBCs) is significant work in analyzing the failure of TBCs. In practical applications, the operating temperature, oxygen partial pressure, aluminium content in TBCs, and porosity of the topcoat affect the oxidation rate. Therefore, a novel oxidation rate model is proposed to describe the effect of such factors. The parameters in the proposed model were fitted with isothermal degradation test data from prior literature. Then, a method for calculating the residual stress in a disk-shaped specimen was developed based on the oxidized growth strain model and the oxidized model. Finally, a variable-temperature oxidation experiment was performed to validate the new oxidation model. The average error between the predicted and experimental thicknesses is approximately 10%, and the average error between the residual stresses is 30%. Under the variable-temperature condition, the error between the predicted thickness and the average experimental thickness is 3.9%.

Electronic Supplementary Material

Download File(s)
cja-37-6-410_ESM.pdf (3.5 MB)

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 410-424

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
TAO Q, WANG Y, WEI D, et al. Thermal oxidation description methodology of thermal barrier coatings on gas turbine blades considering service characteristics. Chinese Journal of Aeronautics, 2024, 37(6): 410-424. https://doi.org/10.1016/j.cja.2024.03.035

1373

Views

14

Crossref

13

Web of Science

13

Scopus

1

CSCD

Received: 05 June 2023
Revised: 16 July 2023
Accepted: 10 September 2023
Published: 28 March 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).