AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

A numerical simulation strategy for a compressor’s underlying axisymmetric characteristic and its application in body force model

Shijie LIUa, Tianyu PANb( ), Qiushi LIb,c
School of Energy and Power Engineering, Beihang University, Beijing 100191, China
Research Institute of Aero-Engine, Beihang University, Beijing 100191, China
Key Laboratory of Fluid and Power Machinery, Ministry of Education, Xihua University, Chengdu 610039, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Accurate prediction of the aerodynamic response of a compressor under inlet distortion is crucial for next-generation civil aircraft, such as Boundary Layer Ingestion (BLI) silent aircraft. Therefore, research on the Body Force (BF) model plays a significant role in achieving this objective. However, distorted inlet airflow can lead to varying operating conditions across different spatial locations of the compressor, which may cause some regions to operate outside the stability boundary. Consequently, the accuracy of BF model simulations might be compromised. To address this issue, this paper proposes a numerical simulation strategy for acquiring the steady axisymmetric three-dimensional flow field of a compressor operating at low mass flow rates, which is known as the Underlying Axisymmetric Pressure Rise Characteristic (UAPRC). The proposed simulation accounts for two different rotor speeds of a transonic compressor and identifies initial positions in the flow field where deterioration occurs based on prior experimental investigations. Moreover, simulation results are incorporated into the BF model to replicate hub instability observed in experiments. Obtained results demonstrate that this strategy provides valid predictions of the UAPRC of the compressor, thereby addressing the limitations associated with the BF model.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 79-90

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LIU S, PAN T, LI Q. A numerical simulation strategy for a compressor’s underlying axisymmetric characteristic and its application in body force model. Chinese Journal of Aeronautics, 2024, 37(8): 79-90. https://doi.org/10.1016/j.cja.2024.01.032

705

Views

3

Crossref

3

Web of Science

3

Scopus

0

CSCD

Received: 29 August 2023
Revised: 08 October 2023
Accepted: 02 November 2023
Published: 30 January 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).