AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Numerical and experimental investigation of quantitative relationship between secondary flow intensity and inviscid blade force in axial compressors

Chenghua ZHOUa, Zixuan YUEa, Hanwen GUOa, Xiwu LIUb, Donghai JINa,c( ), Xingmin GUIa,c
School of Energy and Power Engineering, Beihang University, Beijing 100191, China
AECC Hunan Aviation Powerplant Research Institute, Zhuzhou 412002, China
Jiangxi Research Institute of Beihang University, Nanchang 330096, China
Show Author Information

Abstract

The secondary flow attracts wide concerns in the aeroengine compressors since it has become one of the major loss sources in modern high-performance compressors. But the research about the quantitative relationship between secondary flow and inviscid blade force needs to be more detailed. In this paper, a database of 889 three-dimensional linear cascades was built. An indicator, called Secondary Flow Intensity (SFI), was used to express the loss caused by secondary flow. The quantitative relationship between the SFI and inviscid blade force deterioration was researched. Blade oil flow and Computation Fluid Dynamics (CFD) results of some cascades were also used to cross-validate. Results suggested that all numerical cascade cases can be divided into 3 clusters by the SFI, which are called Clusters A, B and C in the order of the increasing SFI indicator. The corner stall, known as the strong corner separation, only happens when the SFI is high. Both calculations and oil flow experiments show that the SFI would stay at a low level if the vortex core at the endwall surface does not appear. The strong interaction of Kutta condition and endwall cross-flow is considered the dominant mechanism of higher secondary flow losses, rather than the secondary flow penetration depth on the suction surface. In conclusion, the inviscid blade force spanwise deterioration is strongly related to the SFI. The correlation of the SFI and spanwise inviscid blade force deterioration is given in this paper. The correlation could provide a quantitative reference for estimating secondary flow losses in the design.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 101-111

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHOU C, YUE Z, GUO H, et al. Numerical and experimental investigation of quantitative relationship between secondary flow intensity and inviscid blade force in axial compressors. Chinese Journal of Aeronautics, 2023, 36(10): 101-111. https://doi.org/10.1016/j.cja.2023.06.012

757

Views

6

Crossref

6

Web of Science

6

Scopus

0

CSCD

Received: 16 September 2022
Revised: 30 September 2022
Accepted: 21 February 2023
Published: 17 June 2023
© 2023 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).