AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Compressor geometric uncertainty quantification under conditions from near choke to near stall

Junying WANGa, Baotong WANGb, Heli YANGb, Zhenzhong SUNb, Kai ZHOUb, Xinqian ZHENGa,b( )
State Key Laboratory of Automotive Safety and Energy, School of Vehicle and Mobility, Tsinghua University, Beijing 100084, China
Department of Aerodynamics and Thermodynamics, Institute for Aero Engine, Tsinghua University, Beijing 100084, China

Peer review under responsibility of Editorial Committee of CJA.

Show Author Information

Abstract

Geometric and working condition uncertainties are inevitable in a compressor, deviating the compressor performance from the design value. It’s necessary to explore the influence of geometric uncertainty on performance deviation under different working conditions. In this paper, the geometric uncertainty influences at near stall, peak efficiency, and near choke conditions under design speed and low speed are investigated. Firstly, manufacturing geometric uncertainties are analyzed. Next, correlation models between geometry and performance under different working conditions are constructed based on a neural network. Then the Shapley additive explanations (SHAP) method is introduced to explain the output of the neural network. Results show that under real manufacturing uncertainty, the efficiency deviation range is small under the near stall and peak efficiency conditions. However, under the near choke conditions, efficiency is highly sensitive to flow capacity changes caused by geometric uncertainty, leading to a significant increase in the efficiency deviation amplitude, up to a magnitude of −3.6%. Moreover, the tip leading-edge radius and tip thickness are two main factors affecting efficiency deviation. Therefore, to reduce efficiency uncertainty, a compressor should be avoided working near the choke condition, and the tolerances of the tip leading-edge radius and tip thickness should be strictly controlled.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics
Pages 16-29

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
WANG J, WANG B, YANG H, et al. Compressor geometric uncertainty quantification under conditions from near choke to near stall. Chinese Journal of Aeronautics, 2023, 36(3): 16-29. https://doi.org/10.1016/j.cja.2022.10.012

859

Views

55

Crossref

51

Web of Science

55

Scopus

7

CSCD

Received: 15 February 2022
Revised: 21 March 2022
Accepted: 09 May 2022
Published: 02 November 2022
© 2021 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).