AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

Pseudolock phenomenon in locking plate osteosynthesis: classification and epidemiology in upper limb

Xiang YAO1,2, Han MIAO2, Shengjie LIU2,3, Rongyang SHAO2, Yilin TANG2, Jilei TANG4, Minjie HU1 ( )
Department of Orthopaedics, the Affiliated People’s Hospital of Jiangsu University, Zhenjiang 212000
School of Medicine, Jiangsu University, Zhenjiang 212013
Department of Burn and Plastic Surgery, the Affiliated People’s Hospital of Jiangsu University, Zhenjiang 212000
Department of Orthopaedics, Qidong Hospital of Traditional Chinese Medicine, Nantong 226200, China
Show Author Information

Abstract

Objective

To clarify the definition of pseudolock phenomenon during locking plate osteosynthesis, propose a novel clinically oriented classification, and explore the incidence and distribution characteristics of this phenomenon.

Methods

According to the insertion state of locking head screws in the threaded holes of locking plates, the pseudolock phenomenon was classified into three types: Type A, the screw depth is insufficient, but the orientation is normal in a precontoured plate; Type B, both the screw depth and orientation are abnormal in a precontoured plate; Type C, the screw depth and orientation are either/both abnormal in an overbent plate. Demographic and radiographic data of 1796 patients with upper limb long bone fractures (clavicle, humerus, ulna, and radius) who underwent locking plate osteosynthesis from June 2017 to April 2024 were collected and analyzed. A Chi-square test with Bonferroni correction was used to assess the incidence of pseudolock incidences across different genders, ages, sites, sides, locations, and diameters.

Results

A total of 1878 locking plates were identified in the long bones of the upper limbs, distributed as follows: clavicle 1129 (60.1%), humerus 364 (19.4%), ulna 137 (7.3%), and radius 248 (13.2%). In total, 11636 locking head screws placed in these plates were included in the analysis, of which 2564 (22.0%) were pseudolocked. Type A pseudolock was the most common with an incidence of 14.1% (1646/11636), followed by Type B at 7.8% (911/11636), while Type C was rare with an incidence of 0.1% (7/11636).

Conclusion

The pseudolock phenomenon in locking plate osteosynthesis is defined and a new classification system is established. The incidence of pseudolock exceeds 20% in osteosynthesis of upper extremity long bones including clavicle, humerus, ulna and radius. Mastering the preset insertion depth and orientation of screws for locking plates and identifying pseudolock timely via tangential fluoroscopy during operation are crucial measures to improve the fixation stability of locking plates.

CLC number: R681.7 Document code: A Article ID: 1007-4368(2026)06-894-09

References

【1】
【1】
 
 
Journal of Nanjing Medical University (Natural Sciences)
Pages 894-902

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
YAO X, MIAO H, LIU S, et al. Pseudolock phenomenon in locking plate osteosynthesis: classification and epidemiology in upper limb. Journal of Nanjing Medical University (Natural Sciences), 2026, 46(6): 894-902. https://doi.org/10.7655/NYDXBNSN251464

2

Views

0

Downloads

0

Crossref

Received: 25 December 2025
Revised: 29 April 2026
Accepted: 30 April 2026
Published: 15 June 2026
© 2026 Editorial Board of Journal of Nanjing Medical University(Natural Sciences)

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).