AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (17.3 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Mechanism of seawater hydrothermal aging and tensile damage characteristics of composite materials

Tianzhen LI1, Jingchao WEI2, Yong CAO1( ), Jingyu LIU1, Yongcun LI1, Wenzhi WANG3
Institute of Applied Mechanics, Taiyuan University of Technology, Taiyuan 030024, China
National Key Laboratory of Strength and Structural Integrity, Aircraft Strength Research Institute of China, Xi'an 710065, China
School of Aeronautics, Northwestern Polytechnical University, Xi'an 710072, China
Show Author Information

Abstract

The hot and humid, salt-laden of seawater can affect the properties and service life of composite materials. Hygrothermal aging tests were conducted on Carbon Fiber Rein-forced Polymer (CFRP) in air, pure water, seawater, and seawater with a tenfold concentration. The moisture absorption model for seawater aging under cyclic temperature variation was modified based on Fick's diffusion law. Additionally, quasistatic tensile tests were performed to assess the mechanical properties after the composites absorbed moisture to saturation. A stepwise coupled simulation strategy that accounts for hygrothermal stress is proposed to predict the tensile damage behavior of composites after moisture absorption. In this strategy, the hygrothermal stress field is obtained incrementally, and the resulting stress is incorporated into the tensile simulation model. This approach allows the effects of hygrothermal expansion on material cracking to be included in the mechanical calculations. Based on experimental results and simulations, the moisture absorption characteristics and tensile damage behavior of composites under various environmental conditions after moisture absorption were investigated. The main findings are as follows: the modified moisture absorption model and the stepwise coupled simulation strategy effectively characterize the hygroscopic process in multi-concentration environments at cyclic temperatures and the effects of hygrothermal expansion on material mechanical properties. Saturated moisture absorption decreases with increasing concentration, and the rate of moisture absorption is directly proportional to temperature but inversely proportional to concentration. The modulus of elasticity of aged CFRP decreases weakly with increasing concentration, and the strength limit decreases slightly. The degradation of the resin matrix properties is the primary aging influence. The failure modes of specimens affected by aging can be categorized as sheet fracture, explosive fiber-strip fragmentation, and fiber-resin pullout damage. These modes are due to the more pronounced aging effects of higher seawater concentration on the resin matrix, resulting in weakened fiber-resin bonding.

CLC number: V258;O341 Document code: A Article ID: 1000-6893(2025)22-431729-15

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LI T, WEI J, CAO Y, et al. Mechanism of seawater hydrothermal aging and tensile damage characteristics of composite materials. Acta Aeronautica et Astronautica Sinica, 2025, 46(22). https://doi.org/10.7527/S1000-6893.2024.31729

1368

Views

15

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 30 December 2024
Revised: 05 March 2025
Accepted: 21 March 2025
Published: 11 April 2025
© 2025 The Journal of Acta Aeronautica et Astronautica Sinica