AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (7.7 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Numerical investigation of inlet performance of an atmosphere-breathing electric propulsion system and its feasibility analysis

Penghui SU1,2, Yihao LIU1,2, Xuhong JIN1,2,3( ), Xiaoli CHENG1,2
China Academy of Aerospace Aerodynamics, Beijing 100074, China
Laboratory of Aero-thermal Protection Technology for Aerospace Vehicles (LAPTAV), China Aerospace Science and Technology Corporation (CASC), Beijing 100074, China
Faculty of Civil Aviation and Aeronautics, Kunming University of Science and Technology, Kunming 650500, China
Show Author Information

Abstract

To achieve a wide-range design for the inlet of the atmosphere-breathing electric propulsion system operating in the upper atmosphere, a comprehensive numerical analysis is performed to investigate gas flows inside the inlet using the direct simulation Monte Carlo method. The effects of inlet geometry and Gas-Surface Interaction (GSI) model on flow features and compression and collection performances are considered, and the underlying physical mechanism is interpreted based on the gas kinetic theory. Results show that when the GSI is completely diffuse reflection, the converging effect induced by the concave inlet leads to a larger gas pressure and mass flux and a high-pressure region closest to the ionization section, while the diverging effect caused by the convex inlet results in a smaller gas pressure and mass flux and a high-pressure region far from the ionization section. When the GSI accommodation coefficient σ=0.5, both the gas pressure and mass flux achieve their local peak values at some locations in the ionization section. The underlying mechanism behind the phenomena is that after reflecting in a specular manner from the concave surface similar to a paraboloid, gas molecules congregate at the focus and enter the ionization section. The drop of GSI accommodation coefficient from 1 to 0.5 brings about a considerable increase in the compression factor and collection efficiency, achieving a rate of increase of 85%-125% and 55%-77%, respectively. For the cases of completely and partially diffuse reflections, the concave inlet has the best compression and collection performances. It can be assumed that with reasonable ionization efficiency and exhaust velocity, the concave inlet with a GSI accommodation coefficient of 0.5 can produce a thrust larger than atmospheric drag at the altitude of 180 km. Therefore, this inlet design is feasible in concept.

CLC number: V411.3 Document code: A Article ID: 1000-6893(2025)16-131569-14

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SU P, LIU Y, JIN X, et al. Numerical investigation of inlet performance of an atmosphere-breathing electric propulsion system and its feasibility analysis. Acta Aeronautica et Astronautica Sinica, 2025, 46(16). https://doi.org/10.7527/S1000-6893.2024.31569

719

Views

8

Downloads

0

Crossref

3

Scopus

1

CSCD

Received: 25 November 2024
Revised: 12 December 2024
Accepted: 30 December 2024
Published: 25 August 2025
© 2025 The Journal of Acta Aeronautica et Astronautica Sinica