AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (7.2 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Neural network model for wing strain-load relationship based on fusion of real and virtual data

Yingjie SHI1,2, Binchao LIU1,2, Songsong LU1( ), Liang CHEN3, Hai SHANG4, Rui BAO1
National Key Laboratory of Strength and Structural Integrity, School of Aeronautic Science and Engineering, Beihang University, Beijing 100191, China
International Innovation Institute, Beihang University, Hangzhou 311115, China
AVIC Shenyang Aircraft Design and Research Institute, Shenyang 110035, China
AVIC Changcheng Institute of Metrology and Measurement, Beijing 100095, China
Show Author Information

Abstract

When establishing a strain-load relationship model for aircraft structures, ground calibration tests can obtain high-fidelity data but are trapped with limited test ranges, while finite element simulations are not limited by test ranges but the data fidelity is low. This leads to difficulties in achieving win-win situation of accuracy and applicability based solely on either ground calibration test data or finite element simulation data. To address the above issue, two multi-level neural network models fusing real and virtual data are put forward, a mapping-based model and a compensation-based model. A method for measuring the model's cognitive degree based on the variance of base learners is established and embedded into the compensation-based model. A neural network model with high accuracy, wide applicability, and the capability to forewarn unreliable prediction results is then developed. This developed model is validated using a scaled-down wing. Compared with complete reliance on real data from ground calibration tests, the load models based on fusion of multi-source data demonstrate superior capabilities, and the compensation-based model is better than the mapping-based one. Moreover, the compensation-based model can effectively identify the data samples with poor cognitive degree of the load model and thereby provide warnings for unreliable prediction results.

CLC number: V214.1 Document code: A Article ID: 1000-6893(2025)19-530921-12

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SHI Y, LIU B, LU S, et al. Neural network model for wing strain-load relationship based on fusion of real and virtual data. Acta Aeronautica et Astronautica Sinica, 2025, 46(19). https://doi.org/10.7527/S1000-6893.2024.30921

681

Views

5

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 09 July 2024
Revised: 02 September 2024
Accepted: 23 September 2024
Published: 11 October 2024
© 2025 The Journal of Acta Aeronautica et Astronautica Sinica