AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (1.9 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Experimental study on EDM of CFRP in aerosol medium

Jiaxuan HAN1, Fan CHEN2, Xuguang YANG2, Zhenyu WANG2, Xiaoming YUE2,3( )
School of Control Science and Engineering, Shandong University, Jinan 250061, China
School of Mechanical Engineering, Shandong University, Jinan 250061, China
Key Laboratory of High-efficiency and Clean Mechanical Manufacture, Ministry of Education, Shandong University, Jinan 250061, China
Show Author Information

Abstract

Carbon Fiber Reinforced Polymer (CFRP) is widely used as an advanced composite material. Traditional cutting methods for processing CFRP are prone to forming machining defects such as delamination, burrs, and cracks, and have the problem of severe tool wear. Laser processingand water jet processing of CFRP are prone to defects such as the heat affected zones, impact damage, and stepped delamination. As a non-contact machining method, Electrical Discharge Machining (EDM) can machine any conductive material regardless of the strength, hardness, and stiffness of the workpiece material. Therefore, EDM has a great potential in solving the difficult machining problem of large CFRP components. However, the EDM of CFRP faces challenges such as the contamination of the CFRP components by the liquid mediumand the limited size of the CFRP components. Therefore, this study proposes to perform the CFRP EDM in an aerosol medium, and builds an EDM milling machine tool based on a six-degree-of-freedom serial robot. The experiments on planarand spatial EDM milling of the CFRP components were conductedand the action mechanism of the droplet in EDM of CFRP material in aerosol medium was revealed, verifying the feasibility of the EDM milling of CFRP in aerosol medium. This study has a great significance for the low-cost, green, and efficient process of largeand complex CFRP thin-walled structural components.

CLC number: V26 Document code: A Article ID: 1000-6893(2025)04-430886-11

References

【1】
【1】
 
 
Acta Aeronautica et Astronautica Sinica

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
HAN J, CHEN F, YANG X, et al. Experimental study on EDM of CFRP in aerosol medium. Acta Aeronautica et Astronautica Sinica, 2025, 46(4). https://doi.org/10.7527/S1000-6893.2024.30886

598

Views

7

Downloads

0

Crossref

1

Scopus

0

CSCD

Received: 28 June 2024
Revised: 08 July 2024
Accepted: 06 October 2024
Published: 25 February 2025
© 2025 The Journal of Acta Aeronautica et Astronautica Sinica