AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Home Capillarity Article
PDF (1.1 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Article | Open Access

The interface shape and contact angle determination for liquid-liquid systems in cylindrical nanopores

Center for Computational Physics, Moscow Institute of Physics and Technology, Dolgoprudnyi 141700, Russia
Joint Institute for High Temperatures of the Russian Academy of Sciences, Moscow 125412, Russia
National Research University Higher School of Economics, Moscow 101000, Russia
Schmidt Institute of Physics of the Earth of RAS, Moscow 123242, Russia
AIRI, Moscow 105064, Russia
Show Author Information

Abstract

Understanding the behavior of immiscible liquids in confined geometries is important for applications in porous media, nanofluidics, and enhanced oil recovery. A geometric model is developed for describing liquid-liquid interfacial boundaries in cylindrical nanopores. This approach extends the predicting angles from nanoscale density analysis methodology from modeling slit pores to cylindrical pores with periodic boundary conditions. Analytical expressions for the geometry of a roll-type interfacial boundary and corresponding one-dimensional density profiles are obtained based on capillary theory. The model includes an effective wetting layer thickness parameter that accounts for molecular-level effects near the solid surface. The proposed expressions were implemented in the predicting angles from nanoscale density analysis software package, where the contact angle, volume fraction, and wetting layer thickness are optimized based on density profiles obtained from molecular dynamics simulations. Validation on synthetic data showed that the method accurately reconstructs interfacial boundary parameters under a wide range of conditions. Molecular dynamics simulations of the benzene-water system in carbon nanotubes confirmed the applicability of the method and revealed a strong dependence of the contact angle and wetting layer thickness on the strength of the solid-liquid interaction strength. An additional comparison with intrinsic interface reconstruction from molecular dynamics configurations shows good agreement between the reconstructed contact angles and direct geometrical analysis of the liquid-liquid interface. The cylindrical constraint significantly affects the geometry of the interfacial boundary and the wetting properties at the nanoscale.

Electronic Supplementary Material

Download File(s)
capi-19-3-86_ESM.pdf (363.4 KB)

References

【1】
【1】
 
 
Capillarity
Pages 86-96

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Vandyshev G, Kondratyuk N, Gerke K, et al. The interface shape and contact angle determination for liquid-liquid systems in cylindrical nanopores. Capillarity, 2026, 19(3): 86-96. https://doi.org/10.46690/capi.2026.06.03

7

Views

0

Downloads

0

Crossref

0

Scopus

Received: 21 April 2026
Revised: 22 May 2026
Accepted: 03 June 2026
Published: 06 June 2026
© The Author(s) 2026.

This article is distributed under the terms and conditions of the Creative Commons Attribution (CC BY-NC-ND) license, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.