AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Article | Open Access

Impact of micro-scale characteristics of shale reservoirs on gas depletion behavior: A microscale discrete model

Key Laboratory of Ministry of Education on Safe Mining of Deep Metal Mines, Northeastern University, Shenyang 110819, P. R. China
Key Laboratory of Liaoning Province on Deep Engineering and Intelligent Technology, Northeastern University, Shenyang 110819, P. R. China
Energy and Mineral Engineering, G3 Center and Energy Institute, Pennsylvania State University, University Park, PA 16802, USA
Hebei Research Center of the Basic Discipline Engineering Mechanics, Shijiazhuang Tiedao University, Shijiazhuang 050043, P. R. China
State Key Laboratory of Continental Shale Oil, Northeast Petroleum University, Daqing 163318, P. R. China
Show Author Information

Abstract

Shale gas has become increasingly significant in the global energy supply. Mineral heterogeneity in shales importantly impacts gas transport within the shale matrix and therefore the depletion history curve. A microscale discrete coupling model is introduced to clarify mass transfer and mechanical interactions, as well as their impact on gas transport properties, ranging from individual mineral through ensemble field scale. The model uses a mineral morphology thin-section obtained through tescan integrated mineral analyzer with the mechanical parameters, controlling both elastic and viscosity behavior of each mineral, achieved through nanoindentation. A coupled model for poromechanical evolution is proposed and solved using COMSOL. The applicability of the model results are validated against field data using a dimensionless approach. This confirms that in the early stages of gas depletion, gas is primarily liberated from inorganic minerals, whereas in later stages, it is predominantly sourced from adsorbed gas from the organic matter. Over time, the permeability of the inorganic minerals decreases, and a higher Young’s modulus of the minerals results in a greater ultimate permeability ratio. Evolution of the effective diffusion coefficient for the organic matter is controlled by multiple components. A negative correlation exists between mineral grain size and the creep effects, indicating that larger grain sizes result in smaller creep magnitudes during gas production. The Young’s modulus of inorganic matter is inversely correlated with the diffusion coefficient, while an increase in the Young’s modulus in the organic matter corresponds to a higher diffusion coefficient. The proposed model complements the traditional continuum dual-medium method and provides a clearer understanding of the interactions between minerals during gas depletion behavior.

References

【1】
【1】
 
 
Advances in Geo-Energy Research
Pages 143-157

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Cheng W, Guo Y, Cui G, et al. Impact of micro-scale characteristics of shale reservoirs on gas depletion behavior: A microscale discrete model. Advances in Geo-Energy Research, 2025, 15(2): 143-157. https://doi.org/10.46690/ager.2025.02.06

1105

Views

80

Downloads

17

Crossref

15

Web of Science

17

Scopus

Received: 06 November 2024
Revised: 01 December 2024
Accepted: 26 December 2024
Published: 02 January 2025
© The Author(s) 2024.

This article is distributed under the terms and conditions of the Creative Commons Attribution (CC BY-NC-ND) license, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.