AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (3.9 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Article | Open Access

A new near-wellbore modeling method for deviated wells in corner-point grid

State Key Laboratory of Petroleum Resources and Engineering, China University of Petroleum (Beijing), Beijing 102249, P. R. China
Department of Exploration and Development, CNOOC Research Institute Co., Ltd, Beijing 100027, P. R. China
Mathematics and Cybernetics, SINTEF Digital, Oslo 0314, Norway
Show Author Information

Abstract

This paper presents the construction of a high-quality, robust hybrid grid for near-wellbore modeling in the vicinity of a deviated well. The far-field region is modeled using a corner-point grid, while the near-wellbore region-referred to as the volume of interest-is remeshed using a layered unstructured grid, which consists of a combination of Voronoi and radial sub-grids. A detailed gridding and simulation workflow is outlined. The construction of the novel layered unstructured grid begins with building a base surface grid on the surface typically aligned to middle well point. The grids on the other surfaces are built through preserving the base topology but adjusting the nodes of base grid to fit the well points deviating from the base well point. A flow-based node rearrangement method is proposed to adjust the grid nodes to gain high-quality grids on each surface. The positions of new nodes are determined by ensuring equal streamlines and pressure values between nodes on the base and target surfaces, improving grid orthogonality as streamlines remain perpendicular to equipotential lines. The method’s ability to generate high-quality grids for deviated wells is demonstrated through illustrative and validation examples. Computational performance is assessed through direct comparisons across three case studies, showing that the new near-wellbore modeling model provides accurate well solutions and pressure maps with a reasonable computational cost. Additionally, the near-wellbore modeling model outperforms standard models in capturing gas flow with high compressibility, describing flow behavior in heterogeneous reservoirs, and predicting production parameters in multilayer systems.

Electronic Supplementary Material

Download File(s)
ager-15-2-112_ESM.pdf (1.7 MB)

References

【1】
【1】
 
 
Advances in Geo-Energy Research
Pages 112-128

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Li J, Zhao L, Møyner O, et al. A new near-wellbore modeling method for deviated wells in corner-point grid. Advances in Geo-Energy Research, 2025, 15(2): 112-128. https://doi.org/10.46690/ager.2025.02.04

1240

Views

108

Downloads

0

Crossref

0

Web of Science

0

Scopus

Received: 21 October 2024
Revised: 18 November 2024
Accepted: 17 December 2024
Published: 23 December 2024
© The Author(s) 2024.

This article is distributed under the terms and conditions of the Creative Commons Attribution (CC BY-NC-ND) license, which permits unrestricted use, distribution, and reproduction in any medium, provided the original work is properly cited.