AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.1 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Characteristics and sources of ore-forming fluids of South Narimalahei copper polymetallic deposit in East Kunlun, Qinghai

Qu SUN1, Li WANG1, Yongsheng ZHANG2, Xingzhu FAN1, Guofeng ZHANG3, Jianhua SHENG4, Xiaohang CHEN5, Xiang LIU5
College of Earth Sciences, Jilin University, Changchun 130061, China
National Gemological Training Center, Beijing 102628, China
Bureau of Geologic Exploration and Mineral Development of Jilin Province, Changchun 130061, China
Yantai Municipal Bureau of Natural Resources and Planning, Yantai 264003, Shandong, China
Geological Survey of Hebei Province, Shijiazhuang 050000, China
Show Author Information

Abstract

The South Narimalahei area is located on the north side of the Middle Kunlun fault in the eastern section of the East Kunlun composite orogenic belt. The ore body is veined and controlled by structures and secondary fissures, which occurs in the structural alteration fracture zone in the Late Triassic granodiorite. In this deposit, copper mineralization is closely related to silicification and sericification. The formation process of the deposit includes hydrothermal mineralization and supergene oxidation. In this paper, the fluid inclusion mineralogy, microscopic temperature measurement and stable isotope studies have been carried out for ore of the main mineralization stage. The results show that the primary gas-liquid two-phase inclusions and a small amount of single-liquid inclusions are mainly developed in the quartz in the main mineralization stage. The results of microscopic temperature measurement show that the ore-forming fluid which has low temperature(151.7℃—205.8℃), low salinity(2.06 wt%—4.94 wt%NaCl), low density(0.86—0.92 g/cm3) and shallow formation(1.5—3.0 km) is a hydrothermal solution of NaCl-H2O system. Hydrogen and oxygen isotope results show that the ore-forming fluids mainly come from atmospheric precipitation, with a small amount of magmatic fluids participating. It is preliminarily determined that the South Narimalahei copper polymetallic deposit is a low-temperature hydrothermal vein deposit.

References

【1】
【1】
 
 
Global Geology
Pages 144-153

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
SUN Q, WANG L, ZHANG Y, et al. Characteristics and sources of ore-forming fluids of South Narimalahei copper polymetallic deposit in East Kunlun, Qinghai. Global Geology, 2021, 24(3): 144-153. https://doi.org/10.3969/j.issn.1673-9736.2021.03.02

550

Views

25

Downloads

0

Crossref

Received: 21 February 2021
Accepted: 08 April 2021
Published: 25 August 2021
© 2021 GLOBAL GEOLOGY