AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (5.9 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access | Just Accepted

Oxide-side lanthanum regulation enables trap-to-relay conversion of hydrogen spillover at MoO2/Ni4Mo interfaces

Kejun Yan1,2, Jiahui Luo1,2, Baoxin Wu2,3, Yongbiao Mu1,2, Zhiqing Tang1,2, Yu Xu1,2, Lei Wei1,2, Lin Zeng1,2 ( )

1 Shenzhen Key Laboratory of Hydrogen Energy, Department of Mechanical and Energy Engineering, Southern University of Science and Technology, Shenzhen 518055, China

2 SUSTech Energy Institute for Carbon Neutrality, Southern University of Science and Technology, Shenzhen 518055, China

3 Department of Mechanical Engineering, The Hong Kong Polytechnic University, Hung Hom, Kowloon, Hong Kong, China

Show Author Information

Abstract

Efficient alkaline hydrogen evolution requires not only rapid water dissociation but also continuous interfacial transport and consumption of hydrogen intermediates. However, alloy/oxide heterointerfaces designed to couple these elementary steps often suffer from electronic mismatch, leading to localized hydrogen intermediates (H*) trapping and interrupted hydrogen spillover. Here, an oxide-side lanthanum-regulated MoO2/Ni4Mo heterostructure is developed to convert the interfacial H* bridge from an electronic trap into a relay-permissive junction. La is preferentially accommodated in the oxygen-coordinated MoO2-side environment, where it attenuates local contact-potential mismatch, redistributes near-Fermi interfacial states, and strengthens alloy/oxide coupling without forming a dominant La-centered hydrogen-evolution site. This electronic reconfiguration enables a continuous MoO2-to-Ni4Mo hydrogen-relay pathway by lowering the interfacial H* migration barrier while maintaining favorable water-activation and H2-release energetics. Consequently, La-MoO2/Ni4Mo delivers an overpotential of 14 mV at 10 mA cm-2 and a Tafel slope of 31.9 mV dec-1 in alkaline electrolyte. When implemented as a cathode in an anion-exchange-membrane water electrolyzer (AEMWE), it achieves 1 A cm-2 at 1.74 V and sustains stable operation for 1000 h at 70 ℃. This work establishes oxide-side lanthanum-mediated interfacial electronic regulation as an effective strategy for constructing spillover-active hydrogen-evolution electrodes for practical alkaline water electrolysis.

Graphical Abstract

References

【1】
【1】
 
 
Nano Research Energy

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Yan K, Luo J, Wu B, et al. Oxide-side lanthanum regulation enables trap-to-relay conversion of hydrogen spillover at MoO2/Ni4Mo interfaces. Nano Research Energy, 2026, https://doi.org/10.26599/NRE.2026.9120292

66

Views

11

Downloads

0

Crossref

0

Web of Science

0

Scopus

Received: 08 October 2026
Revised: 22 September 2026
Accepted: 02 November 2026
Available online: 18 November 2026

© The Author(s) 2026. Published by Tsinghua University Press.

The articles published in this open access journal are distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits use, distribution and reproduction in any medium, provided the original work is properly cited.