AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (6 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access | Just Accepted

Acid corrosion of high-entropy ceramics: Insights from an entropy-stabilized oxide model system

Ying Zhao, Ji-Xuan Liu( ), Guo-Jun Zhang( )

State Key Laboratory of Advanced Fiber Materials, College of Materials Science and Engineering, College of Physics, Donghua University, Shanghai 201620, China

Show Author Information

Abstract

High-entropy engineering has emerged as a promising strategy for designing compositionally complex materials with enhanced structural stability. However, it remains unclear whether high-entropy structures intrinsically improve corrosion resistance. Herein, an entropy-stabilized rock-salt (MgCoNiCuZn)O (HEO) high-entropy oxide was selected as a model system and compared with a mechanically mixed oxide (MO) consisting of MgO, Co3O4, NiO, CuO, and ZnO mixed at equimolar metal-cation ratios. Despite the same nominal cation composition, MO consists of independent oxide phases, whereas HEO forms a single-phase rock-salt solid solution. Hydrochloric-acid immersion experiments reveal distinctly different corrosion pathways. MO undergoes pronounced elemental dissolution selectivity, with Mg-, Zn-, and Cu-containing phases preferentially removed while Ni- and Co-containing phases are relatively retained. In contrast, HEO exhibits substantially reduced elemental dissolution selectivity, consistent with coupled multielement dissolution within the common lattice. Moreover, the corrosion response of HEO strongly depends on acid concentration. HEO exhibits lower net mass loss than MO in 1 M HCl, whereas its degradation becomes substantially more severe in 6 M HCl and the net mass loss exceeds that of MO. Residual HEO retains the multielement rock-salt structure while developing interfacial stratification and localized Cu/Cl-containing corrosion-derived species. These results show that high-entropy solid-solution formation modifies corrosion pathways rather than universally enhancing corrosion resistance, highlighting the coupled roles of phase constitution, constituent chemistry, and environmental aggressiveness in designing corrosion-resistant ceramics.

Graphical Abstract

Electronic Supplementary Material

Download File(s)
JAC1405-ESM.pdf (570.2 KB)

References

【1】
【1】
 
 
Journal of Advanced Ceramics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Zhao Y, Liu J-X, Zhang G-J. Acid corrosion of high-entropy ceramics: Insights from an entropy-stabilized oxide model system. Journal of Advanced Ceramics, 2026, https://doi.org/10.26599/JAC.2026.9221405

280

Views

24

Downloads

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 28 October 2026
Revised: 08 November 2026
Accepted: 08 November 2026
Available online: 10 November 2026

© The Author(s) 2026.

The articles published in this open access journal are distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/).