AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Home Friction Article
PDF (3.6 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research Article | Open Access | Just Accepted

Covalent organic framework/graphene oxide hybrids via in situ polymerization as high-performance lubricant additives

Yue Liua, XiangLi Shena, ChangSheng Chena, Xiaoqiang Fana( ), ZhiHui Xieb( ), Minhao Zhua,c

a Key Laboratory of Advanced Technologies of Materials (Ministry of Education), School of Materials Science and Engineering, Southwest Jiaotong University, Chengdu 610031, China.

b Chemical Synthesis and Pollution Control Key Laboratory of Sichuan Province, College of Chemistry and Chemical Engineering, China West Normal University, Nanchong, 637002, China.

c Tribology Research Institute, School of Mechanical Engineering, Southwest Jiaotong University, Chengdu 610031, China.

Show Author Information

Abstract

Covalent organic frameworks/graphene oxide (COFs/GO) hybrid nanocomposites were synthesized via an in-situ polymerization strategy and evaluated as lubricant additives in polyalphaolefin (PAO 10) under severe operating conditions. Two hybrids, TATP/GO and TADM/GO, were prepared and their tribological performance was systematically investigated. Structural characterization revealed that the in situ growth of TADM increased the interlayer spacing of GO and improved its dispersion behavior in PAO 10. At the optimal concentration of 0.05 wt.%, TADM/GO reduced the friction coefficient and wear volume by 30.43% and 95.58%, respectively, compared with neat PAO 10 in reciprocating sliding tests. Under four-ball conditions with an applied load of 392 N, TADM/GO maintained effective lubrication for 4 h, reducing the friction coefficient and wear volume by 35.71% and 69.37%, respectively. The wear volume after 4 h is only 47.54% higher than that measured in the independent 1 h test, demonstrating sustained anti-wear performance under prolonged severe contact conditions. The superior tribological performance of TADM/GO is attributed to the synergistic effects of surface filling, interlayer sliding, and tribochemical film formation. Raman analysis of the worn surface further revealed improved retention of the conjugated carbon structure in the TADM/GO-derived tribofilm under severe shear. These findings demonstrate the potential of molecularly engineered COF/GO hybrids as lubricant additives for severe contact conditions.

Graphical Abstract

Electronic Supplementary Material

Download File(s)
F1328-ESM.pdf (2.1 MB)

References

【1】
【1】
 
 
Friction

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Liu Y, Shen X, Chen C, et al. Covalent organic framework/graphene oxide hybrids via in situ polymerization as high-performance lubricant additives. Friction, 2026, https://doi.org/10.26599/FRICT.2026.9441328

718

Views

23

Downloads

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 14 March 2026
Revised: 17 September 2026
Accepted: 23 October 2026
Available online: 23 October 2026

© The Author(s) 2026.

This is an open access article under the terms of the Creative Commons Attribution 4.0 International License (CC BY 4.0, http://creativecommons.org/licenses/by/4.0/).