AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (5.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Design of biomimetic aerial-aquatic vehicle based on soft cross-medium technology

Lei ZHANG1,2Zhiyong ZHANG1,2Yang MIAO1,2Jian DUAN1,2Bin LIU1,2( )
Sanya Science and Education Innovation Park, Wuhan University of Technology, Sanya 572025, China
Green & Smart River-Sea-Going Ship Cruise and Yacht Research Center, Wuhan University of Technology, Wuhan 430063, China
Show Author Information

Abstract

Objective

This study aims to develop a concept design for an unmanned aerial-aquatic cross-medium vehicle that can fly in the air and navigate underwater, and features repeatable medium transitions and superior hydrodynamic performance.

Method

After analyzing the shape of manta ray that evolved good fluid dynamics performance through natural selection, 3D scanning and mathematical fitting methods are employed to conduct a configuration study of the unmanned vehicle. To achieve covert propulsion underwater, numerical analysis methods are used to determine the propulsion amplitude and frequency by fitting the swimming gaits of manta ray. To protect the rotor blades and enhance airborne efficiency, an innovative soft hybrid cross-medium approach is developed that uses ducted rotor devices as flight propulsion units. The numerical simulation method is then employed to study the unmanned vehicle's rapid underwater movement, aerial performance, and cross-medium capabilities.

Results

The results show that during underwater navigation, with a biomimetic fish fin swinging cycle of 2 seconds and a maximum swing angle of 15°, the unmanned vehicle achieves a speed of over 3 knots. During aerial flight, with an attack angle of 7° for the hybrid vehicle and rotor speed set at 3 000 r/min, the aerial speed exceeds 100 km/h. During the transition from air to water, the average load is 0.17 MPa, with the maximum load occurring at abrupt structural edges, reaching up to 0.46 MPa stress. Structural strength calculations are performed for applying 0.17 MPa load at the center bottom and 0.46 MPa load at the bottom edge of the vehicle. The maximum stress occurs at the center bottom, measuring 47.94 MPa, with maximum deformation of 0.02 mm.

Conclusion

The designed cross-medium unmanned aerial-aquatic vehicle satisfies the proposed requirements for both aerial and underwater operation. Furthermore, the fluid loads and structural safety during the air-water transition scheme are assessed, ensuring the vehicle's ability to safelyand repeatedly shift between aerial and aquatic environments.

CLC number: U662.2 Document code: A

References

【1】
【1】
 
 
Chinese Journal of Ship Research
Pages 169-179

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHANG L, ZHANG Z, MIAO Y, et al. Design of biomimetic aerial-aquatic vehicle based on soft cross-medium technology. Chinese Journal of Ship Research, 2025, 20(6): 169-179. https://doi.org/10.19693/j.issn.1673-3185.04012

469

Views

5

Downloads

0

Crossref

2

Scopus

3

CSCD

Received: 20 June 2024
Revised: 24 September 2024
Published: 10 December 2024
© 2025 Chinese Journal of Ship Research.