AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (1 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

A Random Forest Fault Diagnosis Method for Photovoltaic Arrays Based on Multi-feature Optimization Mechanism and OOB Optimization

Shoukang LUO1, Kehuan WEN1, Yubo ZHANG1, Xiaojia SUN1, Yang LI1, Wenjing SUN1, Tianfeng LI2( )
Shenzhen Power Supply Bureau Co., Ltd., Shenzhen 518001, Guangdong Province, China
Guangzhou Power Electrical Technology Co., Ltd., Guangzhou 510670, Guangdong Province, China
Show Author Information

Abstract

To address the frequent faults in distributed photovoltaic (PV) arrays and the limitations of traditional random forest (RF) methods in diagnostic accuracy and generalization capability, this paper proposes a fault diagnosis method based on RF that integrates multi-feature optimization and dynamic out-of-bag (OOB) error optimization. First, a PV array simulation model is constructed in MATLAB/Simulink based on the single-diode equivalent circuit of a PV cell. The model simulates five typical fault types, including short circuit, open circuit, partial shading, aging degradation, and bypass diode failure, and extracts multi-dimensional fault features covering voltage, current, and power etc. Furthermore, the OOB error is introduced as a dynamic evaluation metric during model training to monitor and optimize the ensemble strategy of base learners in real time, thereby improving convergence performance and generalization capability. Simultaneously, a two-stage multi-feature optimization strategy—“permutation importance preliminary screening + principal component analysis secondary dimensionality reduction”—is adopted to screen the most critical fault feature subset from the original high-dimensional features, enhancing model robustness. Experimental results demonstrate that the proposed OOB-RF model achieves a fault diagnosis accuracy of 95.44% on the test set, which is 8.12 percentage points higher than that of the traditional RF model, while the overfitting index is significantly reduced by 51.26%. The proposed method exhibits superior classification accuracy and stability, providing an effective solution for the intelligent operation and maintenance of distributed PV systems.

CLC number: TK 51 Document code: A

References

【1】
【1】
 
 
Distributed Energy
Pages 120-128

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LUO S, WEN K, ZHANG Y, et al. A Random Forest Fault Diagnosis Method for Photovoltaic Arrays Based on Multi-feature Optimization Mechanism and OOB Optimization. Distributed Energy, 2026, 11(5): 120-128. https://doi.org/10.16513/j.2096-2185.DE.26100426

0

Views

0

Downloads

0

Crossref

Received: 01 February 2026
Revised: 02 March 2026
Published: 25 October 2026
© Editorial Department of Distributed Energy Journal 2026. Published by Tsinghua University Press.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).