AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

Numerical study on the dual-orifice spray cooling characteristics of phase change microcapsule suspension

Zitong Jiao, Xinlong Wang, Rui Zhao, Jiajie Zhang( ), Yong Li, Suxia Ma
School of Electrical and Power Engineering, Taiyuan University of Technology, Taiyuan 030024, China
Show Author Information

Abstract

For the high heat flux heat dissipation requirements of power batteries in the electric vehicle, this paper undertakes a numerical investigation on the dual-orifice spray cooling of phase-change microcapsule suspensions. The discrete phase model is employed to depict the movement of liquid droplets, the Lagrangian liquid film model is utilized to address the heat transfer in liquid film flow, and the equivalent heat capacity approach is adopted to handle the latent heat absorption of phase-change microcapsule suspensions. The influence laws of key parameters are also analyzed. The research findings reveal that, in contrast to single-orifice spray, in the array spray, due to the interference perturbation of the two spray streams, the stagnation zone coalesces into an interference zone and forms a cross-flow effect. This results in a thicker liquid film and a lower Nusselt number within the interference zone, while the liquid film thickness attains a valley value and the Nusselt number reaches a peak at the edge of the interference zone. The Nusselt number of the heating surface initially increases and subsequently decreases with the augmentation of the suspension mass fraction, achieving the optimal performance at 5%. Neither too small nor too large nozzle spacing is conducive to the spray cooling heat transfer, and the optimal nozzle spacing is S/D=2.67 under the current circumstances. With the increase in the inlet temperature of the spray, the latent heat absorption of the suspension gives rise to an initial increase followed by a decrease in the Nusselt number, and the optimal inlet temperature is θ=-0.11 at this point. The present research results can provide theoretical guidance for the optimal design of spray cooling for the efficient heat dissipation of power batteries.

CLC number: TK124

References

【1】
【1】
 
 
Journal of Northwest University (Natural Science Edition)
Pages 1074-1085

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Jiao Z, Wang X, Zhao R, et al. Numerical study on the dual-orifice spray cooling characteristics of phase change microcapsule suspension. Journal of Northwest University (Natural Science Edition), 2026, 56(5): 1074-1085. https://doi.org/10.16152/j.cnki.xdxbzr.2026-05-009

1

Views

0

Downloads

0

Crossref

0

CSCD

Received: 09 March 2026
Revised: 12 April 2026
Published: 25 October 2026
© The Editorial Department of Journal of Northwest University(Natural Science Edition)2026.

This is an open access article under the CC BY-NC-ND 4.0 license (https://creativecommons.org/licenses/by-nc-nd/4.0/).