Discover the SciOpen Platform and Achieve Your Research Goals with Ease.
Search articles, authors, keywords, DOI, etc.
For the high heat flux heat dissipation requirements of power batteries in the electric vehicle, this paper undertakes a numerical investigation on the dual-orifice spray cooling of phase-change microcapsule suspensions. The discrete phase model is employed to depict the movement of liquid droplets, the Lagrangian liquid film model is utilized to address the heat transfer in liquid film flow, and the equivalent heat capacity approach is adopted to handle the latent heat absorption of phase-change microcapsule suspensions. The influence laws of key parameters are also analyzed. The research findings reveal that, in contrast to single-orifice spray, in the array spray, due to the interference perturbation of the two spray streams, the stagnation zone coalesces into an interference zone and forms a cross-flow effect. This results in a thicker liquid film and a lower Nusselt number within the interference zone, while the liquid film thickness attains a valley value and the Nusselt number reaches a peak at the edge of the interference zone. The Nusselt number of the heating surface initially increases and subsequently decreases with the augmentation of the suspension mass fraction, achieving the optimal performance at 5%. Neither too small nor too large nozzle spacing is conducive to the spray cooling heat transfer, and the optimal nozzle spacing is S/D=2.67 under the current circumstances. With the increase in the inlet temperature of the spray, the latent heat absorption of the suspension gives rise to an initial increase followed by a decrease in the Nusselt number, and the optimal inlet temperature is θ=-0.11 at this point. The present research results can provide theoretical guidance for the optimal design of spray cooling for the efficient heat dissipation of power batteries.
This is an open access article under the CC BY-NC-ND 4.0 license (https://creativecommons.org/licenses/by-nc-nd/4.0/).
Comments on this article