AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (4.6 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese

Equipment interference and correction method in dynamic pressure field verification of low-speed wind tunnel

Jiangtao LIU1, Xiaoquan GONG2, Naichun ZHOU2( ), Ming LI2, Yaobing ZHANG2
Low Speed Aerodynamics Institute,China Aerodynamics Research and Development Center,Mianyang 621000,China
Computational Aerodynamics Institute,China Aerodynamics Research and Development Center,Mianyang 621000,China
Show Author Information

Abstract

As one of the quality indexes of the wind tunnel flow field, the dynamic pressure field of the wind tunnel directly affects the accuracy of experiment results, and the dynamic pressure field needs to be checked regularly. Dynamic pressure field verification equipment includes a five-hole probe, pipe rack, and guide rail (longitudinal beam and cross beam). The influence of verification equipment needs to be deducted when the dynamic pressure field is analyzed. Based on the national general computational fluid dynamics (CFD) software NNW-FlowStar for numerical wind tunnel engineering, a class of low-speed pressure outlet boundary conditions for simulating boundary layer flow was established. The residual convergence and calculation accuracy of the boundary conditions were verified by the low-speed flat plate turbulent boundary layer. Based on unstructured hybrid mesh and FlowStar, the numerical simulation of the FL-12 low-speed wind tunnel test section without any equipment, the test section only with the guide rail of the pipe rack, and the test section with both the pipe rack and the guide rail was carried out. The degree of influence and affected areas of the equipment were qualitatively displayed through a spatial dynamic pressure cloud diagram. The degree of influence of the verification equipment on the dynamic pressure of the test sections was given quantitatively through the spatial dynamic pressure distribution curve. In addition, the state with and without the guide rail of the pipe rack at the top of the test sections was numerically simulated, and the degree of influence of the guide rail of the pipe rack on the dynamic pressure of the test sections was obtained. The guide rail of the pipe rack had a great influence on the adjacent four probes. By decomposing the degree of influence of the verification equipment on the dynamic pressure and comparing the dynamic pressure correction curves of numerical and experimental results, the results show that the degree of influence of the guide rail of the pipe rack on the dynamic pressure of the central probe is six times that of the pipe rack. This verifies the rationality of the experimental dynamic pressure correction scheme ignoring the degree of influence of the pipe rack, and optimization suggestions to improve the accuracy of dynamic pressure verification are proposed.

CLC number: V211.3 Document code: A Article ID: 1001-5965(2025)05-1651-11

References

【1】
【1】
 
 
Journal of Beijing University of Aeronautics and Astronautics
Pages 1651-1661

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LIU J, GONG X, ZHOU N, et al. Equipment interference and correction method in dynamic pressure field verification of low-speed wind tunnel. Journal of Beijing University of Aeronautics and Astronautics, 2025, 51(5): 1651-1661. https://doi.org/10.13700/j.bh.1001-5965.2023.0310

594

Views

23

Downloads

0

Crossref

1

Scopus

0

CSCD

Received: 02 June 2023
Published: 10 November 2023
© Journal of Beijing University of Aeronautics and Astronautics