AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.9 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

Effect of polyolefin polyol content on polyurethane elastomer structure and performance

XiaoGang GE1, Jun ZHANG2( ), MengLong HAO3, JianFeng LIU1, HaiXia WANG1
Shanxi Jinbei Expressway Maintenance Co., Ltd., Taiyuan 030006
High-Tech Research Institute, Beijing University of Chemical Technology, Beijing 100029
Shanxi Transportation Planning Survey and Design Institute Co., Ltd., Taiyuan 030006, China
Show Author Information

Abstract

Polyurethane elastomers were prepared in a one-step method with polyolefin polyols bearing long side chains, liquefied diphenylmethane diisocyanate, and 2-ethyl-1,3-hexanediol as raw materials. The effect of polyolefin polyol content on the chemical structure, mechanical properties, water resistance, thermal stability, and thermal transition behavior of the polyurethane elastomers was investigated. The results showed that as the polyolefin polyol content decreased, the hardness of the polyurethane elastomers gradually increased, the tensile strength first increased and then decreased, and the elongation at break gradually decreased. When the polyolefin polyol content was 60%, the tensile strength reached a maximum value of 6.2 MPa, with a corresponding elongation at break of 283%. The polyurethane elastomers exhibited excellent water resistance, with a water absorption rate below 0.5% and a water contact angle greater than 98°. The initial thermal decomposition temperature (Td5%) gradually decreased with decreasing polyolefin polyol content reaching a minimum value of 291 ℃. The soft and hard segments in the polyurethane elastomers exhibited independent glass transition temperatures that showed little variation (the differences between the maximum and minimum values were 1.3 ℃ and 0.7 ℃, respectively), demonstrating the presence of a clear microphase-separated structure in the polyurethane elastomers.

CLC number: TQ334.1

References

【1】
【1】
 
 
Journal of Beijing University of Chemical Technology (Natural Science Edition)
Pages 52-57

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
GE X, ZHANG J, HAO M, et al. Effect of polyolefin polyol content on polyurethane elastomer structure and performance. Journal of Beijing University of Chemical Technology (Natural Science Edition), 2026, 53(5): 52-57. https://doi.org/10.13543/j.bhxbzr.2026.05.006

2

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 22 September 2025
Published: 20 September 2026
© 2026 The Authors.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).