AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (972.1 KB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

Synthesis and properties of a polystyrene-modified polyurethane microporous elastomer

YiFu CHANG, FanQing ZHANG, Jun ZHANG, JinXin REN, Xin DING, ZhiGuo JIANG, Ming YAO( )
College of Materials Science and Engineering, Beijing University of Chemical Technology, Beijing 100029, China
Show Author Information

Abstract

Using polymer polyols with polystyrene (PS) side chains (POP-S), polyether polyol, 4,4′-diphenylmethane diisocyanate (MDI), and styrene as the main raw materials, a PS-modified polyurethane-grafted interpenetrating network microporous elastomer was prepared via stepwise addition polymerisation of polyurethane (PU) and radical graft polymerization of styrene.With increasing styrene content, the tensile strength, elongation at break, and tear strength of the microporous elastomer all increased, and the material exhibits a low dynamic-static stiffness ratio and good compression set performance. When the apparent density of the microporous elastomer is 0.5 g/cm3 with a PS mass fraction of 47%, the compression set value is as low as 5%, the dynamic-static stiffness ratio is as low as 1.08, the impact resilience is 76.3%, the tensile strength is 3.14 MPa, and the elongation at break is 483%. This microporous elastomer has great potential for use in large-scale building vibration damping pads.

CLC number: TQ323.8; TQ334.9

References

【1】
【1】
 
 
Journal of Beijing University of Chemical Technology (Natural Science Edition)
Pages 46-51

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
CHANG Y, ZHANG F, ZHANG J, et al. Synthesis and properties of a polystyrene-modified polyurethane microporous elastomer. Journal of Beijing University of Chemical Technology (Natural Science Edition), 2026, 53(5): 46-51. https://doi.org/10.13543/j.bhxbzr.2026.05.005

1

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 23 May 2025
Published: 20 September 2026
© 2026 The Authors.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).