AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (3.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

Effects of different homogenization treatments on color and stability of fish skin and bone steam-exploded broth

Guosheng ZHANG, Yueru LIU, Zijuan LI, Tao YIN, Juan YOU, Shanbai XIONG, Ru LIU ( )
College of Food Science and Technology, Huazhong Agricultural University/National R&D Branch Center for Conventional Freshwater Fish Processing (Wuhan)/Engineering Research Center of Green Development for Conventional Aquatic Biological Industry in the Yangtze River Economic Belt, Ministry of Education, Wuhan 430070, China
Show Author Information

Abstract

To address the issues of low utilization rate of freshwater surimi by-products (Fish skin and bone) and the poor stability of the broth system, we employed the steam explosion method to prepare fish skin and bone broth. We compared the effects of three homogenization methods (Colloid mill JTM, high-pressure homogenizer JZJ, and high-pressure microjet nano-homogenizer WSL) at different processing times (10, 20, 30, 40, 50 min) on the color and stability of the steam-exploded broth. The results show that after homogenization treatment using the three methods, the lightness (L*) and whiteness (W) values increased, while the yellow-blue chromaticity (b*) value and particle size decreased. The viscosity and absolute value of the ζ-potential increased. Meanwhile, the dispersion stability improved significantly (p<0.05). Compared with the JTM group, the JZJ and WSL groups could more significantly reduce the number of fat globules in the broth, and decrease the particle size of fat globules and fish skin and bone particles more significantly, which led to higher L* and W values (p<0.05). The WSL group showed superior particle size distribution uniformity, although the average particle sizes among the three groups showed no significant difference. At the same homogenization time, the WSL group samples exhibited the highest viscosity and absolute ζ-potential value. The ΔBS and TSI values indicate that the stability of the broth samples followed a descending order of WSL>JZJ>JTM. The optimal stability of the broth was at 40, 20, and 50 minutes for JTM, JZJ, and WSL homogenization, respectively. In summary, it is suggested to use a high-pressure homogenizer to prepare steam-exploded broth for 20 minutes in industry.

CLC number: TS 254.4 Document code: A Article ID: 2095-0780-(2025)06-0001-09

References

【1】
【1】
 
 
South China Fisheries Science
Pages 1-9

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
ZHANG G, LIU Y, LI Z, et al. Effects of different homogenization treatments on color and stability of fish skin and bone steam-exploded broth. South China Fisheries Science, 2025, 21(6): 1-9. https://doi.org/10.12131/20250174

5

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 09 August 2025
Revised: 14 September 2025
Published: 05 December 2025
© Editorial Office of South China Fisheries Science.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).