AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

Influencing factors of gas-liquid two-phase flow in oxygenation speece cone of aquaculture tanks

Liqun LIN, Yaoming ZHANG, Ping LIU, Zhiqiang XU, Mingchao CUI
Fishery Machinery and Instrument Research Institute, Chinese Academy of Fishery Sciences/Key Laboratory of Fishery Equipment and Engineering, Ministry of Agriculture and Rural Affairs, Shanghai 200092, China
Show Author Information

Abstract

To understand the characteristics of gas-liquid two-phase flow in the speece cone and improve its oxygenation performance, taking the speece cone in an oxygenation system of large-scale aquaculture platform cabin as the subject, we carried out a two-dimensional transient numerical simulation of gas-liquid two-phase flow in the speece cone under different conditions (Gas inlet method, taper and aperture size) based on the Euler-Euler model, analyzed the gas volume fraction distribution, the internal flow field pressure and the velocity distribution, explored the flow law of gas-liquid two-phase in the speece cone, and determined the key structural parameters influencing the aeration and oxygen dissolving performance of the speece cone. According to the results, under a given air inlet flow, when the gas inlet was consistent with the water inlet from speece cone, the mixing degree of gas and water was high. The experimental verification shows that the speece cone with top inlet had the best dissolved oxygen performance compared with the left inlet method and right inlet method. When the speece cone had the same volume, changes in the taper of the speece cone led to gas-liquid two-phase changed: a smaller taper, a higher speece cone, and longer motion path and mixing time of oxygen in the speece cone, favoring full oxygen dissolution. By the same gas inlet method, the gas-liquid two-phase distribution was similar in the speece cone. The volume fraction of the speece cone outlet gas increased with decreasing air inlet aperture, and when the air inlet aperture was reduced to d =10 mm, the gas and liquid were best mixed in the speece cone.

CLC number: S 951.3 Document code: A Article ID: 2095-0780-(2025)03-0036-08

References

【1】
【1】
 
 
South China Fisheries Science
Pages 36-43

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LIN L, ZHANG Y, LIU P, et al. Influencing factors of gas-liquid two-phase flow in oxygenation speece cone of aquaculture tanks. South China Fisheries Science, 2025, 21(3): 36-43. https://doi.org/10.12131/20240224

0

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 23 September 2024
Revised: 17 December 2024
Published: 05 June 2025
© Editorial Office of South China Fisheries Science.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).