AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (11.1 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Publishing Language: Chinese | Open Access

A method for estimating quantity of Trachinotus ovatus in marine cage aquaculture based on high-frequency horizontal mechanical scanning sonar image

Jiazhen HU1,2, Jialong SUN1,3, Xiaohua HUANG2, Guohao ZHU1,2, Qiyou TAO2,4, Taiping YUAN2,5, Gen LI2,5, Guoliang PANG2,5, Yu HU2,5( ), Mingyang LI1
Jiangsu Ocean University, Lianyungang 222005, China
South China Sea Fisheries Research Institute, Chinese Academy of Fishery Sciences/Key Laboratory of South China Sea Fishery Resources Exploitation & Utilization, Ministry of Agriculture and Rural Affairs, Guangzhou 510300, China
Jiangsu Marine Resources Development Research Institute, Lianyungang 222005, China
Southern Marine Science and Engineering Guangdong Laboratory (Zhuhai), Zhuhai 519000, China
Tropical Fisheries Research and Development Center, South China Sea Fisheries Research Institute, Chinese Academy of Fishery Sciences, Sanya 572018, China
Show Author Information

Abstract

To estimate the quantity of Trachinotus ovatus in marine cages accurately, a method for estimating the quantity of fish is proposed by using high-frequency horizontal mechanical scanning sonar and deep learning technology. Differentiating water layers and clustering layer by layer to realize counting is the main way of this method, which mainly involves three parts: fish identification, fish cluster and fish quantity fitting. Firstly, high-frequency horizontal mechanical scanning sonar is used to conduct spiral detection on marine cages to obtain fish image information, which is labeled to build training data set of improved CS-YOLOv8s. After training, the CS-YOLOv8s model is used to recognize fish location information in the images. Secondly, the cages are divided into water layers with a water depth spacing of 40 cm, and the identification coordinate data of each water layer are clustered through DBSCAN method to generate fish quantity data of each water layer. Finally, the quantity data of each water layer is fitted with the given quantity of fish in the cage, and the fitting model of fish quantity is established. The results show that in the quantitative experiment of marine cages, the accuracy of this method is 87.14%, and it can achieve a good estimation of the quantity of T. ovatus.

CLC number: S 932.4 Document code: A Article ID: 2095-0780-(2024)05-0113-13

References

【1】
【1】
 
 
South China Fisheries Science
Pages 113-125

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
HU J, SUN J, HUANG X, et al. A method for estimating quantity of Trachinotus ovatus in marine cage aquaculture based on high-frequency horizontal mechanical scanning sonar image. South China Fisheries Science, 2024, 20(5): 113-125. https://doi.org/10.12131/20240042

0

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 06 March 2024
Revised: 11 June 2024
Published: 05 October 2024
© Editorial Office of South China Fisheries Science.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).