Discover the SciOpen Platform and Achieve Your Research Goals with Ease.
Search articles, authors, keywords, DOI, etc.
To meet the manufacturing requirements for bimetallic or dual-performance components, the effects of various joining parameters and interlayer materials on the microstructure and tensile properties of diffusion-bonded Ti150/Ti180 joints are investigated. Microstructure and fracture surface of the joints are systematically studied using optical microscope, scanning electron microscopy, energy spectrum and X-ray diffractometer. Tensile properties of the joints are tested by universal testing machine. The results show that sound metallurgical bonding at the interface is achieved without an interlayer at bonding temperatures ranging from 800 ℃ to 900 ℃. Moreover, as the bonding temperature increases, the joint tensile strength gradually improves. Under the condition of 900 ℃/1 h/15 MPa, the joint achieves tensile strengths of 941 MPa at room temperature and 609 MPa at 450 ℃, corresponding to 86.2% and 81.3% of Ti150 alloy, respectively. However, the joint plasticity remains low. When Ti foil is used as the interlayer, residual Ti foil is observed in the joint under the condition of 900 ℃/10 MPa/2 h, indicating insufficient diffusion between the Ti foil and the base metals. The tensile strengths of these joints are comparable to those of joints bonded without an interlayer. When Ti55 titanium alloy is employed as the interlayer, the joint tensile strength reaches 992 MPa after bonding at 930 ℃/15 MPa/1 h, approximately 90.8% of Ti150 alloy, and the joint plasticity is also improved. Nevertheless, the tensile strength at 450 ℃ remains at a level similar to that of the other joints.
This is an open access article under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).
Comments on this article