AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (17.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Publishing Language: Chinese | Open Access

Formation mechanism and suppression method of out-of-plane buckling defect of unidirectional prepreg

Zhengzheng MA, Hongliang ZHENG, Cuihong PAN, Yanan TIAN, Hongfei ZHOU( )
AVIC Composite Co.,Ltd.,Beijing 101300,China
Show Author Information

Abstract

Prepreg is one of the raw materials for the efficient preparation of composite components. Identifying and improving its appearance defects is of great significance for improving the preparation and use efficiency of prepreg. In this work, aiming at the out-of-plane buckling defect of unidirectional prepreg after cutting and standing, the mechanism and main influencing factors of the defect are studied by aging analysis method, process parameter experiment and process auxiliary material comparison test. The results show that the spontaneous out-of-plane buckling defect of unidirectional prepreg is due to the accumulation of tensile deformation of release paper during the production process. After cutting, the aging shrinkage of release paper induces the debonding of prepreg and release paper to form out-of-plane buckling defect. The formation process of this defect is a pure physical change, which has little effect on the resin content of prepreg. The process comparison test shows that the rotation speed difference between the rollers in the prepreg production process is the main reason for the deformation accumulation of the release paper. The comparison test of process aids shows that the use of high modulus release paper for prepreg preparation can effectively inhibit the occurrence of out-of-plane buckling defects.

CLC number: V255.1 Document code: A Article ID: 1005-5053(2026)11-0077-09

References

【1】
【1】
 
 
Journal of Aeronautical Materials
Pages 77-85

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
MA Z, ZHENG H, PAN C, et al. Formation mechanism and suppression method of out-of-plane buckling defect of unidirectional prepreg. Journal of Aeronautical Materials, 2026, 46(11): 77-85. https://doi.org/10.11868/j.issn.1005-5053.2026.000018

1

Views

0

Downloads

0

Crossref

0

Scopus

0

CSCD

Received: 23 January 2026
Accepted: 29 April 2026
Published: 15 November 2026
© Journal of Aeronautical Materials 2026.

This is an open access article under the CC BY-NC license (http://creativecommons.org/licenses/by-nc/4.0/).