AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (11.2 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Paper | Open Access

Coking behavior during the cooling process of cracked hydrocarbon fuels: Characterization of coke and elucidation of condensation coking mechanism

Liu-Ru Liua,b, Yu Liua,b, Lang Luoa,b, Xin-Ke Wanga,b, Wen-Rui Yana,b, Bo Wanga,b( ), Quan Zhua,b
School of Chemical Engineering, Sichuan University, Chengdu, 610065, Sichuan, China
Engineering Research Center of Combustion and Cooling for Aerospace Power, Ministry of Education, Sichuan University, Chengdu, 610065, Sichuan, China

Peer review under the responsibility of China University of Petroleum (Beijing).

Edited by Min Li

Show Author Information

Abstract

The active cooling technology of endothermic hydrocarbon fuels is a key way to solve the thermal protection of high-speed aircraft engines, but the condensation coking problem during engine shutdown is a bottleneck that affects the reusability of aircraft. In this study, a self-designed apparatus was used to separately analyze the condensation coking during the fuel cooling process, and the coking characteristics under different temperature conditions were obtained. The condensation coking mechanism of fuel during cooling process was proposed based on the changes in physical properties of coking precursors obtained by the group contribution method. When the temperature drops to 300 ℃, not only the gas yield and conversion increase to 71.42% and 89.75% respectively, but the coke mass on the inner surface of the tube also significantly increases from 0.39 to 1.92 mg. Meanwhile, as the temperature further decreases, the morphology of coke gradually transforms into amorphous carbon with a higher degree of graphitization. During the cooling process, due to the liquefaction of coking precursors, their physical properties such as viscosity, density, and saturated vapor pressure undergo sudden changes at 300 ℃, leading to enhanced intermolecular physical interactions and promoting the physical aggregation of coking precursor molecules, which are deposited on the inner wall of the tube. This work provides a theoretical basis for the subsequent study of condensation coking mechanisms and inhibition methods.

References

【1】
【1】
 
 
Petroleum Science
Pages 4781-4793

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Liu L-R, Liu Y, Luo L, et al. Coking behavior during the cooling process of cracked hydrocarbon fuels: Characterization of coke and elucidation of condensation coking mechanism. Petroleum Science, 2025, 22(11): 4781-4793. https://doi.org/10.1016/j.petsci.2025.08.019

1051

Views

5

Downloads

3

Crossref

2

Web of Science

2

Scopus

0

CSCD

Received: 15 December 2024
Revised: 23 March 2025
Accepted: 11 August 2025
Published: 18 August 2025
© 2025 The Authors.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).