AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (2.4 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Paper | Open Access

Analysis on adsorption capacity of coal, gas content and methane carbon isotope characteristics in coal: A case study from Southwestern Qinshui Basin, China

Ya Menga,b( ), Bin Zhanga,b, Feng-Peng Laia,b
School of Energy Resources, China University of Geosciences (Beijing), Beijing, 100083, PR China
Beijing Key Laboratory of Geology Evaluation and Development of Unconventional Natural Gas, China University of Geosciences (Beijing), Beijing 100083, PR China

Edited by Xi Zhang and Jie Hao

Peer review under the responsibility of China University of Petroleum (Beijing).

Show Author Information

Abstract

The methane adsorption capacity, gas content, and carbon isotope characteristics of coal are crucial parameters that determine the productivity of coalbed methane (CBM) wells and their development potential. In this paper, test analyses of methane adsorption, gas content and carbon isotope of methane were carried out using 89 samples from the No.3 coal seam in the southwestern part of the Qinshui Basin. Their characteristics and correlations were analyzed. A relationship model between methane adsorption, gas content, carbon isotopes, coal metamorphism and material composition were established, and its controlling mechanism was investigated. The results indicate that the distribution patterns of Langmuir volume and Langmuir pressure in No.3 coal seam are mainly determined by the material composition and the thermal evolution level. The methane gas content in coal is mainly affected by the burial depth, microcosmic composition, mineral content, moisture content and ash yield, adsorption capacity and metamorphism of the coal. The methane carbon isotope (δ13C1) values in the natural desorbed gas from No.3 coal seam range from −26.95% to −57.80‰, with a mean value of −34.53‰. δ13C1 in coal shows a two-stage variation pattern with increasing in vitrinite reflectance (Rmaxo). When Rmaxo is blow 3.0%, δ13C1 values of methane in coal become progressively heavier with increasing Rmaxo. When Rmaxo reaches or exceeds 3.0%, δ13C1 values exhibit a lightning trend with further increases in Rmaxo, which is primarily controlled by the carbon isotope fractionation effects during thermal evolution.

References

【1】
【1】
 
 
Petroleum Science
Pages 4381-4393

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Meng Y, Zhang B, Lai F-P. Analysis on adsorption capacity of coal, gas content and methane carbon isotope characteristics in coal: A case study from Southwestern Qinshui Basin, China. Petroleum Science, 2025, 22(11): 4381-4393. https://doi.org/10.1016/j.petsci.2025.08.010

1008

Views

1

Downloads

9

Crossref

6

Web of Science

6

Scopus

0

CSCD

Received: 28 June 2024
Revised: 09 April 2025
Accepted: 05 August 2025
Published: 08 August 2025
© 2025 The Authors.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).