AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (3.7 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Original Paper | Open Access

Pressure transient behavior of fractured wells in multilayered tight gas reservoirs with heterogeneous properties and limited fracture height

Jing-Jing Guo( ), Chao-Zhi Jiang, Hai-Tao Wang( ), Lie-Hui Zhang
State Key Laboratory of Oil and Gas Reservoir Geology and Exploitation, Southwest Petroleum University, Chengdu, 610500, Sichuan, China

Edited by Yan-Hua Sun

Show Author Information

Abstract

Hydraulic fracturing and commingle production of multiple layers are extensively adopted in unconventional tight gas reservoirs. Accurate determination of parameters of individual layers in multilayered tight gas reservoirs is essential for well performance evaluation and development strategy optimization. However, most analytical models for fractured vertical wells in stratified gas reservoirs focus on fully penetrated hydraulic fractures, neglecting the influence of partial penetration of hydraulic fractures. This paper presents a semi-analytical model to investigate the transient pressure behavior of vertically fractured wells in dual porosity multi-layered tight gas reservoirs. The partial penetration of hydraulic fracture, the vertical heterogeneities of layer properties, the differences between hydraulic fracture lengths in each layer and the stress sensitivity are all incorporated in the proposed model. The point-source solution, Laplace transformation, Fourier transformation, Pedrosa's transformation, perturbation technique, and the superposition principle are applied to obtain the analytical solution of transient pressure responses. The proposed model is validated against a commercial software, and the transient pressure behavior of vertically fractured wells in multi-layered tight gas reservoirs are analyzed. Based on the characteristics of the type curves, seven flow regimes can be identified, including wellbore storage, transitional flow period, reservoir linear flow period, vertical pseudo-radial flow in fracture system, inter-porosity flow period, late-time pseudo-radial flow period, and the boundary-dominated flow period. Sensitivity analyses reveal that the penetration ratio of hydraulic fracture has primary influence on early-time transient pressure behavior and production contribution, while the stress sensitivity mainly affects the late-time transient pressure behavior. Gas production at the initial stage is mainly contributed by the high-pressure/high-permeability layer, and gas backflow will occur during initial production stage for obviously unequal initial formation pressures. Finally, two field cases are conducted to illustrate the applicability of the proposed model. The model and corresponding conclusions can provide technical support for performance analysis of tight gas reservoirs.

References

【1】
【1】
 
 
Petroleum Science
Pages 3357-3379

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Guo J-J, Jiang C-Z, Wang H-T, et al. Pressure transient behavior of fractured wells in multilayered tight gas reservoirs with heterogeneous properties and limited fracture height. Petroleum Science, 2025, 22(8): 3357-3379. https://doi.org/10.1016/j.petsci.2025.05.002

659

Views

2

Downloads

6

Crossref

4

Web of Science

6

Scopus

0

CSCD

Received: 16 September 2024
Revised: 08 May 2025
Accepted: 08 May 2025
Published: 08 May 2025
© 2025 The Authors.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).