A seismic elastic moduli module for the measurements of low-frequency wave dispersion and attenuation of fluid-saturated rocks under different pressures

Knowledge about the seismic elastic modulus dispersion, and associated attenuation, in fluid-saturated rocks is essential for better interpretation of seismic observations taken as part of hydrocarbon identification and time-lapse seismic surveillance of both conventional and unconventional reservoir and overburden performances. A Seismic Elastic Moduli Module has been developed, based on the forced-oscillations method, to experimentally investigate the frequency dependence of Young's modulus and Poisson's ratio, as well as the inferred attenuation, of cylindrical samples under different confining pressure conditions. Calibration with three standard samples showed that the measured elastic moduli were consistent with the published data, indicating that the new apparatus can operate reliably over a wide frequency range of f∈[1–2000, 10⁶] Hz. The Young's modulus and Poisson's ratio of the shale and the tight sandstone samples were measured under axial stress oscillations to assess the frequency- and pressure-dependent effects. Under dry condition, both samples appear to be nearly frequency independent, with weak pressure dependence for the shale and significant pressure dependence for the sandstone. In particular, it was found that the tight sandstone with complex pore microstructure exhibited apparent dispersion and attenuation under brine or glycerin saturation conditions, the levels of which were strongly influenced by the increased effective pressure. In addition, the measured Young's moduli results were compared with the theoretical predictions from a scaled poroelastic model with a reasonably good agreement, revealing that the combined fluid flow mechanisms at both mesoscopic and microscopic scales possibly responsible for the measured dispersion.