AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (29.7 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Review | Open Access

Post processing of additive manufactured Mg alloys: Current status, challenges, and opportunities

Nooruddin Ansari, Fatima Ghassan Alabtah, Mohammad I. Albakri, Marwan Khraisheh( )
Mechanical Engineering Program, Texas A & M University at Qatar, P. O. Box 23874, Doha, Qatar
Show Author Information

Abstract

Magnesium (Mg) and its alloys are emerging as a structural material for the aerospace, automobile, and electronics industries, driven by the imperative of weight reduction. They are also drawing notable attention in the medical industries owing to their biodegradability and a lower elastic modulus comparable to bone. The ability to manufacture near-net shape products featuring intricate geometries has sparked huge interest in additive manufacturing (AM) of Mg alloys, reflecting a transformation in the manufacturing sectors. However, AM of Mg alloys presents more formidable challenges due to inherent properties, particularly susceptibility to oxidation, gas trapping, high thermal expansion coefficient, and low solidification temperature. This leads to defects such as porosity, lack of fusion, cracking, delamination, residual stresses, and inhomogeneity, ultimately influencing the mechanical, corrosion, and surface properties of AM Mg alloys. To address these issues, post-processing of AM Mg alloys are often needed to make them suitable for application. The present article reviews all post-processing techniques adapted for AM Mg alloys to date, including heat treatment, hot isostatic pressing, friction stir processing, and surface peening. The utilization of these methods within the hybrid AM process, employing interlayer post-processing, is also discussed. Optimal post-processing conditions are reported, and their influence on the microstructure, mechanical, and corrosion properties are detailed. Additionally, future prospects and research directions are proposed.

References

【1】
【1】
 
 
Journal of Magnesium and Alloys
Pages 1283-1310

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Ansari N, Alabtah FG, Albakri MI, et al. Post processing of additive manufactured Mg alloys: Current status, challenges, and opportunities. Journal of Magnesium and Alloys, 2024, 12(4): 1283-1310. https://doi.org/10.1016/j.jma.2024.04.017

795

Views

10

Downloads

78

Crossref

73

Web of Science

76

Scopus

0

CSCD

Received: 19 March 2024
Revised: 10 April 2024
Accepted: 15 April 2024
Published: 27 April 2024
© 2024 Chongqing University.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer review under responsibility of Chongqing University