AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (13.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

On dry machining of AZ31B magnesium alloy using textured cutting tool inserts

Shailendra Pawanr, Kapil Gupta( )
Department of Mechanical and Industrial Engineering Technology, University of Johannesburg, Doornfontein Campus, Johannesburg 2028 South Africa
Show Author Information

Abstract

Magnesium alloys have many advantages as lightweight materials for engineering applications, especially in the fields of automotive and aerospace. They undergo extensive cutting or machining while making products out of them. Dry cutting, a sustainable machining method, causes more friction and adhesion at the tool-chip interface. One of the promising solutions to this problem is cutting tool surface texturing, which can reduce tool wear and friction in dry cutting and improve machining performance. This paper aims to investigate the impact of dimple textures (made on the flank face of cutting inserts) on tool wear and chip morphology in the dry machining of AZ31B magnesium alloy. The results show that the cutting speed was the most significant factor affecting tool flank wear, followed by feed rate and cutting depth. The tool wear mechanism was examined using scanning electron microscope (SEM) images and energy dispersive X-ray spectroscopy (EDS) analysis reports, which showed that at low cutting speed, the main wear mechanism was abrasion, while at high speed, it was adhesion. The chips are discontinuous at low cutting speeds, while continuous at high cutting speeds. The dimple textured flank face cutting tools facilitate the dry machining of AZ31B magnesium alloy and contribute to ecological benefits.

References

【1】
【1】
 
 
Journal of Magnesium and Alloys
Pages 1608-1618

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Pawanr S, Gupta K. On dry machining of AZ31B magnesium alloy using textured cutting tool inserts. Journal of Magnesium and Alloys, 2024, 12(4): 1608-1618. https://doi.org/10.1016/j.jma.2024.04.007

610

Views

6

Downloads

19

Crossref

16

Web of Science

17

Scopus

0

CSCD

Received: 06 March 2024
Revised: 05 April 2024
Accepted: 06 April 2024
Published: 25 April 2024
© 2024 Chongqing University.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer review under responsibility of Chongqing University