AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (20.7 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Effect of low concentration electrolytes on the formation and corrosion resistance of PEO coatings on AM50 magnesium alloy

Peng Xiea( ), Carsten Blawerta, Maria Serdechnovaa, Natalia Konchakovaa, Tatsiana Shulhaa, Ting Wua, Mikhail L. Zheludkevicha,b
Institute of Surface Science, Helmholtz-Zentrum Hereon, Max-Planck Strasse 1, 21502 Geesthacht, Germany
Institute for Materials Science, Faculty of Engineering, Kiel University, Kaiserstrasse 2, 24143 Kiel, Germany
Show Author Information

Abstract

In this paper, the formation process, morphology, and electrochemical performance of PEO coatings on AM50 magnesium alloy prepared in low concentration phosphate, aluminate, and phosphate-aluminate electrolytes were systematically studied. The results show that the coatings prepared from the phosphate electrolytes have a higher thickness and better corrosion resistance properties compared to the other electrolytes. The coatings prepared from low concentration phosphate-aluminate mixed electrolytes have slightly thinner thickness, a similar coating structure and an order of magnitude lower value of electrochemical impedance compared with phosphate electrolyte coatings. The Coatings prepared from low concentration aluminate electrolytes have the lowest thickness and the worst corrosion resistance properties which gets close to corrosion behavior of the bare AM50 under the same test conditions. Considering application, coatings prepared from single low concentration phosphate electrolytes and low concentration phosphate-aluminate electrolytes have greater potential than single low concentration aluminate coatings. However, reducing the electrolyte concentrations of coating forming ions too much has negative influence on the coating growth rate.

References

【1】
【1】
 
 
Journal of Magnesium and Alloys
Pages 1386-1405

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Xie P, Blawert C, Serdechnova M, et al. Effect of low concentration electrolytes on the formation and corrosion resistance of PEO coatings on AM50 magnesium alloy. Journal of Magnesium and Alloys, 2024, 12(4): 1386-1405. https://doi.org/10.1016/j.jma.2024.01.020

599

Views

18

Downloads

33

Crossref

24

Web of Science

31

Scopus

0

CSCD

Received: 16 October 2023
Revised: 19 December 2023
Accepted: 14 January 2024
Published: 24 January 2024
© 2024 Chongqing University.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer review under responsibility of Chongqing University