AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (25.3 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Interplay of laser power and pore characteristics in selective laser melting of ZK60 magnesium alloys: A study based on in-situ monitoring and image analysis

Weijie Xiea,b, Hau-Chung Mana,c( ), Chi-Wai Chanb( )
Department of Industrial and Systems Engineering, The Hong Kong Polytechnic University, Hong Kong, China
School of Mechanical and Aerospace Engineering, Queen′s University, Belfast BT9 5AH, UK
Research Institute for Advanced Manufacturing, The Hong Kong Polytechnic University, Hong Kong, China
Show Author Information

Abstract

This study offers significant insights into the multi-physics phenomena of the SLM process and the subsequent porosity characteristics of ZK60 Magnesium (Mg) alloys. High-speed in-situ monitoring was employed to visualise process signals in real-time, elucidating the dynamics of melt pools and vapour plumes under varying laser power conditions specifically between 40 W and 60 W. Detailed morphological analysis was performed using Scanning-Electron Microscopy (SEM), demonstrating a critical correlation between laser power and pore formation. Lower laser power led to increased pore coverage, whereas a denser structure was observed at higher laser power. This laser power influence on porosity was further confirmed via Optical Microscopy (OM) conducted on both top and cross-sectional surfaces of the samples. An increase in laser power resulted in a decrease in pore coverage and pore size, potentially leading to a denser printed part of Mg alloy. X-ray Computed Tomography (XCT) augmented these findings by providing a 3D volumetric representation of the sample internal structure, revealing an inverse relationship between laser power and overall pore volume. Lower laser power appeared to favour the formation of interconnected pores, while a reduction in interconnected pores and an increase in isolated pores were observed at higher power. The interplay between melt pool size, vapour plume effects, and laser power was found to significantly influence the resulting porosity, indicating a need for effective management of these factors to optimise the SLM process of Mg alloys.

References

【1】
【1】
 
 
Journal of Magnesium and Alloys
Pages 1346-1366

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Xie W, Man H-C, Chan C-W. Interplay of laser power and pore characteristics in selective laser melting of ZK60 magnesium alloys: A study based on in-situ monitoring and image analysis. Journal of Magnesium and Alloys, 2024, 12(4): 1346-1366. https://doi.org/10.1016/j.jma.2023.11.005

636

Views

7

Downloads

17

Crossref

0

Web of Science

21

Scopus

0

CSCD

Received: 26 July 2023
Revised: 05 October 2023
Accepted: 02 November 2023
Published: 10 December 2023
© 2023 Chongqing University.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer review under responsibility of Chongqing University