AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (20.9 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Formation of I1 stacking fault by deformation defect evolution from grain boundaries in Mg

Yong-Jie Hua,b, Vaidehi Menona, Liang Qia( )
Department of Materials Science and Engineering, University of Michigan, Ann Arbor 48109, USA
Department of Materials Science and Engineering, Drexel University, Philadelphia 19104, USA
Show Author Information

Abstract

I1 stacking faults (SFs) in Mg alloys are regarded as the nucleation sites of 〈c+a〉 dislocations that are critical for these alloys to achieve high ductility. Previously it was proposed that the formation of I1 SFs requires the accumulations of a large number of vacancies, which are difficult to achieve at low temperatures. In this study, molecular dynamics (MD) and molecular statics (MS) simulations based on empirical interatomic potentials were applied to investigate the deformation defect evolutions from the symmetric tilt grain boundaries (GBs) in Mg and Mg-Y alloys under external loading along 〈c〉-axis. The results show the planar faults (PFs) on Pyramidal I planes first appear due to the nucleation and glide of ⟨ 1 2 c + p ⟩ partial dislocations from GBs, where ⟨ p ⟩ = 1 3 ⟨ 10 1 ¯ 0 ⟩. These partial dislocations with pyramidal PFs interact with other defects, including pyramidal PFs themselves, GBs, and 〈p〉 partial dislocations, generating a large amount of I1 SFs. Detailed analyses show the nucleation and growth of I1 SFs are achieved by atomic shuffle events and deformation defect reactions without the requirements of vacancy diffusion. Our simulations also suggest the Y clusters at GBs can reduce the critical stress for the formation of pyramidal PFs and I1 SFs, which provide a possible reason for the experimental observations that Y promotes the 〈c+a〉 dislocation activities.

References

【1】
【1】
 
 
Journal of Magnesium and Alloys
Pages 2717-2729

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Hu Y-J, Menon V, Qi L. Formation of I1 stacking fault by deformation defect evolution from grain boundaries in Mg. Journal of Magnesium and Alloys, 2022, 10(10): 2717-2729. https://doi.org/10.1016/j.jma.2022.07.010

417

Views

5

Downloads

17

Crossref

16

Web of Science

16

Scopus

3

CSCD

Received: 16 April 2022
Revised: 12 June 2022
Accepted: 05 July 2022
Published: 06 August 2022
© 2022 Chongqing University.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/) Peer review under responsibility of Chongqing University