AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (28.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Open Access

Comparative assessment of NIF and PCAIM for inverting equivalent fault slip in far-field scenarios

Zhengdong Luoa, Tieding Lua,b,c,d, Li Yane( ), Weijian Hua,b,c,d,e
School of Surveying and Geoinformation Engineering, East China University of Technology, Nanchang 330013, China
National Key Laboratory of Uranium Resource Exploration-Mining and Nuclear Remote Sensing, Nanchang 330013, China
Key Laboratory of Mine Environmental Monitoring and Improving Around Poyang Lake of Ministry of Natural Resources, East China University of Technology, Nanchang 330013, China
Jiangxi Key Laboratory of Watershed Ecological Process and Information, East China University of Technology, Nanchang 330013, China
Guangzhou City University of Technology, Guangzhou 510850, China
Show Author Information

Abstract

The study utilized GPS deformation time series, network inversion filter (NIF), and principal component analysis based inversion method (PCAIM) to invert for postseismic equivalent fault slip, obtaining the spatiotemporal evolution characteristics of regional fault slip, and investigating the performance of the two methods in a far-field postseismic inversion scenario. Firstly, the NIF inverted equivalent slip is influenced by the different baseline motion scaling parameter τ. When τ ≤ 0.1 mm/a1/2, the influence on the slip amount basically stabilizes, with the change value tending to be within 5 mm. Secondly, PCAIM exhibits a stronger dependence on the fault model compared to NIF, and the inverted slip distribution is more sensitive to changes in the number of discretized subfaults. Finally, taking the 2011 regional equivalent slip in the Tokai of Japan as an example, the PCAIM inversion time (0.14 h) is far shorter than the NIF inversion time (7.79 h). The inverted postseismic slip propagation area (34.0°N–35.6°N, 136.8°E−138.0°E) is significantly larger than the NIF inverted propagation area (34.8°N–35.8°N, 137.2°E−138.4°E). The maximum slip amount is 1.81 cm larger than that of NIF, and the propagation range is wider. Concurrently, the MAE and RMSE for the surface displacement vectors predicted by PCAIM are both lower than those predicted by NIF, indicating that the PCAIM method exhibits superior surface displacement prediction performance in this scenario.

References

【1】
【1】
 
 
Geodesy and Geodynamics
Pages 822-835

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Luo Z, Lu T, Yan L, et al. Comparative assessment of NIF and PCAIM for inverting equivalent fault slip in far-field scenarios. Geodesy and Geodynamics, 2026, 17(6): 822-835. https://doi.org/10.1016/j.geog.2026.01.006

4

Views

0

Downloads

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 17 September 2025
Revised: 07 December 2025
Accepted: 04 January 2026
Published: 23 February 2026
© 2026 Editorial office of Geodesy and Geodynamics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).