AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (17.2 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Open Access

PPP-based UAV modeling using Galileo HAS orbit/clock products and RTS smoother

Jia Songa,c, Peng Lia,c, Lewen Zhaob,c,d,e( ), Yuanjin Panb, Meilin Heb
Geographic Information and Tourism, Chuzhou University, Chuzhou 239000, China
Remote Sensing and Geomatics Engineering, Nanjing University of Information Science and Technology, Nanjing 210044, China
Anhui Province Key Laboratory of Physical Geographic Environment, Chuzhou University, Chuzhou 239000, China
Anhui Engineering Laboratory of Geo-information Smart Sensing and Services, Chuzhou 239000, China
Anhui Center for Collaborative Innovation in Geographical Information Integration and Application, Chuzhou 239000, China
Show Author Information

Abstract

Unmanned aerial vehicle (UAV) remote sensing and mapping using real-time kinematic (RTK) require reference-station corrections and suffer from accuracy degradation over long baselines. To address these limitations, we evaluate the performance of UAV mapping using Precise Point Positioning (PPP) with Galileo High Accuracy Service (HAS) corrections. A Rauch-Tung-Striebel (RTS) smoother is employed to mitigate the convergence issues inherent in PPP. Various PPP solution modes are assessed using dual-frequency L1/L5 UAV observations across multiple platforms and orbit/clock products. Comparisons were conducted from multiple perspectives, including UAV PPP accuracy, checkpoint accuracy, model-derived perimeter, two-dimensional (2D) area, three-dimensional (3D) surface area, and volume. Results show that UAV PPP using rapid products approached RTK, whereas real-time products reduced precision. The horizontal standard deviation (STD) of checkpoints using Galileo HAS products was 6.5 cm, comparable to RTK and to PPP using rapid products; all were less accurate than the post-processed kinematic (PPK) result of 5.3 cm. The root-mean-square (RMS) errors with Galileo HAS were 5.7 cm (North), 12.9 cm (East), and 22.9 cm (Up), indicating pronounced systematic biases attributable to the short observation span and the lower accuracy of real-time products. Regarding model-derived metrics, the perimeter and 2D area from Galileo HAS PPP solutions were comparable to RTK and were minimally affected. By contrast, vertical systematic biases propagated into the 3D metrics: surface-area errors were <0.9% for both rapid and real-time PPP, whereas volume errors were approximately 3% for the rapid PPP solution and approximately 8% for the near real-time PPP solution.

References

【1】
【1】
 
 
Geodesy and Geodynamics
Pages 797-807

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Song J, Li P, Zhao L, et al. PPP-based UAV modeling using Galileo HAS orbit/clock products and RTS smoother. Geodesy and Geodynamics, 2026, 17(6): 797-807. https://doi.org/10.1016/j.geog.2026.01.002

3

Views

0

Downloads

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 04 November 2025
Revised: 29 December 2025
Accepted: 21 January 2026
Published: 09 March 2026
© 2026 Editorial office of Geodesy and Geodynamics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).