AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (67.5 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Open Access

The multi-fault rupture and strain partitioning revealed by the coseismic surface deformation of the 2022 MS6.9 Menyuan earthquake

Qiaozhe Ruana, Xiaoli Liua,b( ), Xin Lic, Yu Huangd, Juntao Liua, Zhige Jiaa,b
Institute of Seismology, China Earthquake Administration, Wuhan 430071, China
Hubei Earthquake Administration, Wuhan 430071, China
Qinghai Earthquake Administration, Xining 810001, China
Guangdong Provincial Key Laboratory of Geodynamics and Geohazards, School of Earth Science and Engineering, Sun Yat-sen University, Zhuhai 510275, China
Show Author Information

Abstract

This study integrated centimeter-level unmanned aerial vehicle (UAV) data, meter- to sub-meter-resolution Gaofen (GF) satellite imagery, and field investigations to map the coseismic surface ruptures and obtain a high-resolution three-dimensional surface deformation field for the 2022 MS6.9 Menyuan earthquake. Seismological evidence, particularly from high-precision aftershock relocation, was incorporated to constrain the deep fault geometry. The results reveal that the earthquake produced three surface rupture zones: a continuous NWW-trending primary rupture zone (approximately 23 km) along the western segment of the Lenglongling fault; a discontinuous NWW-trending secondary rupture zone (approximately 8.5 km) on its northern side; and a discontinuous NEE-trending secondary rupture zone (approximately 5.6 km) along the eastern segment of the Tuolaishan fault. The maximum surface sinistral offset (3.4 ± 0.3 m) occurred on the primary rupture zone approximately 3 km east of the epicenter, coinciding with the peak seismic moment release at depth. Notably, the northern secondary fault (S3) exhibited dominant thrust motion, different from the strike-slip-dominated primary rupture, highlighting kinematic partitioning among faults. Surface uplift and horizontal shortening were identified near the epicenter within a restraining bend (approximately 800 m long, 200 m wide). We propose that the apparent negative off-fault deformation (OFD) values in the strike-slip direction are compensated by near-field horizontal shortening and vertical uplift. This mechanism, particularly evident in geometrically complex regions such as fault bends and branches, underscores the importance of incorporating multi-fault interactions and geometric complexities into OFD assessments for a comprehensive understanding of coseismic strain partitioning.

References

【1】
【1】
 
 
Geodesy and Geodynamics
Pages 739-754

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Ruan Q, Liu X, Li X, et al. The multi-fault rupture and strain partitioning revealed by the coseismic surface deformation of the 2022 MS6.9 Menyuan earthquake. Geodesy and Geodynamics, 2026, 17(6): 739-754. https://doi.org/10.1016/j.geog.2025.12.015

3

Views

0

Downloads

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 14 September 2025
Revised: 19 November 2025
Accepted: 10 December 2025
Published: 18 February 2026
© 2026 Editorial office of Geodesy and Geodynamics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).