AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (25.1 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research paper | Open Access

Coseismic deformation and hierarchical rupture processes of the 2024 Wushi earthquake revealed by Sentinel-1 InSAR and gradient techniques

Xu Zhanga,b, Qiang Shena,b( ), Liming Jianga,b, Hansheng Wanga,b, C.K. Shumc, Yan Ana,b, Fan Gaoa,b
State Key Laboratory of Precision Geodesy, Innovation Academy for Precision Measurement Science and Technology, Chinese Academy of Sciences, Wuhan 430077, China
College of Earth and Planetary Sciences, University of Chinese Academy of Sciences, Beijing 100049, China
Division of Geodetic Science, School of Earth Sciences, The Ohio State University, Columbus, OH 43210, USA
Show Author Information

Abstract

On January 23, 2024, an MW7.0 earthquake struck Wushi County, Xinjiang, China, near the boundary between the Tianshan Orogen and the Tarim Basin. To resolve the source geometry and surface rupture features, we employed differential interferometric SAR (DInSAR) using both ascending and descending Sentinel-1 data. Inversion of the coseismic deformation fields reveals that the rupture occurred on a northwest-dipping thrust fault with a strike of 225.6° and a dip angle of 67.3°. To enhance the detection of shallow fracturing, we applied a phase gradient stacking technique, which successfully delineated distributed surface ruptures—including several off-fault features—that are not discernible in conventional unwrapped interferograms. These linear anomalies exhibit variable orientations and clustering patterns, suggesting complex near-surface strain partitioning. Furthermore, Coulomb stress modeling based on the inverted slip distribution indicates stress loading exceeding +5 MPa along the northeastern Maidan–Shayilamu fault, implying increased postseismic hazard, while a stress shadow is identified to the southwest. This study demonstrates the effectiveness of integrating InSAR deformation analysis, phase gradient enhancement, and stress transfer modeling in characterizing oblique-thrust faulting and near-field ground response. Our results provide new constraints on rupture behavior in transpressional settings and contribute to seismic hazard assessment in the active intracontinental orogenic zone of the southern Tianshan.

References

【1】
【1】
 
 
Geodesy and Geodynamics
Pages 701-712

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Zhang X, Shen Q, Jiang L, et al. Coseismic deformation and hierarchical rupture processes of the 2024 Wushi earthquake revealed by Sentinel-1 InSAR and gradient techniques. Geodesy and Geodynamics, 2026, 17(6): 701-712. https://doi.org/10.1016/j.geog.2025.12.006

4

Views

0

Downloads

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 15 October 2025
Revised: 10 December 2025
Accepted: 29 December 2025
Published: 23 February 2026
© 2026 Editorial office of Geodesy and Geodynamics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).