AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
PDF (12.1 MB)
Collect
Submit Manuscript AI Chat Paper
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Research | Open Access

Microscopic pore combination type identification of tight sandstone reservoir based on improved swin transformer architecture

Zhenyu Panga,b, Zhicong Chena( ), Sijie Lua, Zhenbo Caic, Yuqing Luc, Mengting Pengc
School of Software, East China University of Technology, Nanchang, 330013, Jiangxi, China
Jiangxi Nuclear Geoscience Data Science and Systems Engineering Technology Research Center, Nanchang, 330013, Jiangxi, China
School of Information Engineering, East China University of Technology, Nanchang, 330013, Jiangxi, China

Peer review under the responsibility of Editorial Board of Energy Geoscience.

Handling Editor: Li Dong

Show Author Information

Abstract

Tight sandstone reservoirs differ fundamentally from conventional medium to high permeability reservoirs due to their complex and heterogeneous microscopic pore structures. This complexity poses significant challenges for accurate reservoir characterization and often results in suboptimal development performance. The specific configuration of microporosity combinations plays a decisive role in determining the storage and seepage capacities of tight sandstone reservoirs. Therefore, the precise identification of microporosity combination types is essential for improving both reservoir evaluation accuracy and development effectiveness. However, traditional computer vision models exhibit limitations in capturing fine-grained textures and spatial relationships among microscopic pores with complex morphologies, leading to inadequate generalization capabilities. To address these issues, this study proposes an enhanced Swin Transformer-based neural network architecture, termed SwinLSC (Swin Transformer with Linformer and Self-Adaptive Channel Attention). The model incorporates a global-local attention mechanism and is trained on image datasets of cast thin sections from tight sandstone reservoirs in the Yanchang Oilfield. To evaluate model performance, Top-1 Accuracy, Loss, and Recall metrics were employed, and the SwinLSC model was benchmarked against three mainstream architectures: Swin Transformer, Vision Transformer (ViT), and ResNet. Experimental results demonstrate that SwinLSC achieves a prediction accuracy of 93.3%, significantly outperforming the comparative models. These findings indicate that the SwinLSC model effectively addresses the generalization deficiencies of conventional approaches in recognizing microstructural features in cast thin section imagery. Consequently, it offers a robust and accurate solution for microporosity type identification, thereby providing reliable technical support for the efficient exploration and development of tight sandstone reservoirs.

References

【1】
【1】
 
 
Energy Geoscience

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
Pang Z, Chen Z, Lu S, et al. Microscopic pore combination type identification of tight sandstone reservoir based on improved swin transformer architecture. Energy Geoscience, 2025, 6(4). https://doi.org/10.1016/j.engeos.2025.100450

590

Views

0

Downloads

3

Crossref

3

Web of Science

3

Scopus

Received: 13 May 2025
Revised: 28 June 2025
Accepted: 07 August 2025
Published: 01 December 2025
© 2025 Petroleum Exploration and Production Research Institute Corporation, SINOPEC.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).