AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Density measurements of aviation kerosene RP-3 over temperature range from 323 K to 783 K under supercritical pressures from 6 MPa to 8 MPa

Yanchen FUa,b, Weitong LIUa,b, Shenzhou SHIc, Ruoyu WANGa,b, Yinlong LIUa,b, Guoqiang XUa,b( )
Research Institute of Aero-engine, Beihang University, Beijing 100191, China
Collaborative Innovation Center for Advanced Aero-Engine, Beihang University, Beijing 100191, China
Beijing Power Machinery Institute, Beijing 100074, China

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

Aviation kerosene RP-3 is extensively used in China. This paper details the measurement of the density of Chinese aviation kerosene RP-3 employing the flow method under high-pressure and high-temperature conditions. The methodology utilizes circular tubes with two different diameters. The density of aviation kerosene RP-3 was experimentally measured for the first time within a pressure range from 6 MPa to 8 MPa and a temperature range from 323 K to 783 K, with a maximum relative uncertainty of 0.35%. The experimental setup used n-decane for calibration, achieving an average calibration error of 0.91%. The data indicate that the density of RP-3 ranges from 764 kg/m3 to 247 kg/m3 under the tested conditions. The results show that the density of kerosene RP-3 decreases with an increase in temperature at a constant pressure, and at a given temperature, a higher pressure results in a higher density. Polynomial fitting was applied to the data, resulting in the average absolute deviation of 1.09%, 0.80%, and 0.76% at different pressures of 6, 7, and 8 MPa, respectively.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
FU Y, LIU W, SHI S, et al. Density measurements of aviation kerosene RP-3 over temperature range from 323 K to 783 K under supercritical pressures from 6 MPa to 8 MPa. Chinese Journal of Aeronautics, 2025, 38(7). https://doi.org/10.1016/j.cja.2025.103474

2

Views

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 18 June 2024
Revised: 22 July 2024
Accepted: 08 September 2024
Published: 10 March 2025
© 2025 The Authors. Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).