AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Role of AP–HMX mass ratio in combustion and agglomeration of NEPE propellant

Shipo LIa,b, Gangchui ZHANGa,b, Zhan WENa,b, Lu LIUa,b, Xiang LVa,b( ), Peijin LIUa,b,c, Wen AOa,b,c ( )
National Key Laboratory of Solid Rocket Propulsion, Xi’an 710072, China
School of Astronautics, Northwestern Polytechnical University, Xi’an 710072, China
Ningbo Institute of Northwestern Polytechnical University, Ningbo 315000, China

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

AP (Ammonium Perchlorate) and HMX (Octogen) are the two oxidizers most often used in Nitrate-Ester-Plasticized Polyether (NEPE) rocket propellants. How the AP–HMX ratio influences the agglomeration of NEPE propellants remains unclear. We experimentally investigated the effect of the AP–HMX ratio on the combustion and agglomeration of NEPE propellants using burning rate test, quenched surface analysis, microscopic observations, and the collection of condensed combustion products. It was found that with the decrease in AP content from 40wt% to 10wt%, the burning rate decreased from 14.2 mm/s to 9.2 mm/s because the adiabatic flame temperature of NEPE propellants decreased from 3828 K to 3736 K. Pockets bounded by AP particles appeared on the surface when AP content was 40wt%; however, the accumulations grew and covered the burning surface eventually as the AP–HMX ratio decreased. The time required for the accumulation to coalesce into agglomerates increased with decreasing AP content. Even with similar agglomerate sizes, the coalescence time increased by 83% when the AP content decreased from 40wt% to 30wt%. The agglomerate size in the Condensed Combustion Products (CCPs) increased from 100 μm to 200 μm, and the fraction of large agglomerations increased from 6.4% to 24.7% when the AP content decreased from 40wt% to 10wt%. Overall, the high flame temperature of the AP particles enhanced the decomposition of the surrounding binder, resulting in the rapid ejection of the aluminum particles into the gas, which had a separating effect on the accumulation, thus weakening the agglomeration.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LI S, ZHANG G, WEN Z, et al. Role of AP–HMX mass ratio in combustion and agglomeration of NEPE propellant. Chinese Journal of Aeronautics, 2025, 38(7). https://doi.org/10.1016/j.cja.2025.103470

3

Views

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 02 June 2024
Revised: 08 July 2024
Accepted: 03 September 2024
Published: 07 March 2025
© 2025 The Author(s). Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).