AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Full Length Article | Open Access

Feedforward compensation-based L1 adaptive control for aeropropulsion system test facility and hardware-in-the-loop verification

Jiashuai LIUa, Ai HEa( ), Xitong PEIa, Yifu LONGb
Institute for Aero Engine, Tsinghua University, Beijing 100084, China
School of Energy and Power Engineering, Beihang University, Beijing 100191, China

☆ Special Issue: Excellent Papers of AFC and ADAC.

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

Aeropropulsion System Test Facility (ASTF) is required to accurately control the pressure and temperature of the airflow to test the performance of the aero-engine. However, the control accuracy of ASTF is significantly affected by the flow disturbance caused by aero-engine acceleration and deceleration. This would reduce the credibility of ASTF’s test results for the aero-engine. Therefore, first, this paper proposes a feedforward compensation-based L1 adaptive control method for ASTF to address this problem. The baseline controller is first designed based on ideal uncoupled closed-loop dynamics to achieve dynamic decoupling. Then, L1 adaptive control is adopted to deal with various uncertainties and ensure good control performance. To further enhance the anti-disturbance performance, a feedforward strategy based on disturbance prediction is designed in the L1 adaptive control framework to compensate for the unmatched flow disturbance, which cannot be measured directly. In addition, this strategy takes into account the effects of actuator dynamics. With this method, the feedforward term can be determined from the nominal model parameters despite uncertainties. Finally, to demonstrate the effectiveness of the proposed method, various comparative experiments are performed on a hardware-in-the-loop system of ASTF. The experimental results show that the proposed method possesses excellent tracking performance, anti-disturbance performance and robustness.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
LIU J, HE A, PEI X, et al. Feedforward compensation-based L1 adaptive control for aeropropulsion system test facility and hardware-in-the-loop verification. Chinese Journal of Aeronautics, 2025, 38(3). https://doi.org/10.1016/j.cja.2024.103386

893

Views

9

Crossref

7

Web of Science

10

Scopus

0

CSCD

Received: 23 August 2024
Revised: 18 September 2024
Accepted: 18 December 2024
Published: 31 December 2024
© 2024 The Author(s). Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).