AI Chat Paper
Note: Please note that the following content is generated by AMiner AI. SciOpen does not take any responsibility related to this content.
{{lang === 'zh_CN' ? '文章概述' : 'Summary'}}
{{lang === 'en_US' ? '中' : 'Eng'}}
Chat more with AI
Article Link
Collect
Show Outline
Outline
Show full outline
Hide outline
Outline
Show full outline
Hide outline
Open Access

Analysis and optimization of microchannel array precision grinding processes with micro-structured micro-grinding tool

Jianfei JIAa,b, Qinghe ZHANGb, Wei YANGa( ), Honghui YAOc, Guicheng WUd, Huan ZHAOe, Jianhui ZHUa, Kenan LIa, Bing GUOb( ), Jun QINf
Zhengzhou Abrasive Grinding Research Institute Co., Ltd, State Key Laboratory for High Performance Tools, Zhengzhou 450001, China
Center for Precision Engineering, School of Mechatronics Engineering, Harbin Institute of Technology, Harbin 150001, China
Zhongshan Sprecision Technology Co., Ltd, Zhongshan 528437, China
Sichuan Aerospace Fenghuo Servo Control Technology Co Ltd, Chengdu 611130, China
State Key Laboratory of Intelligent Manufacturing Equipment and Technology, School of Mechanical Science and Engineering, Huazhong University of Science and Technology, Wuhan 430074, China
Shanxi Aerospace Qinghua Equipment Co., Ltd, Changzhi 046012, China

Peer review under responsibility of Editorial Committee of CJA

Show Author Information

Abstract

Micro-grinding has been widely used in aerospace and other industry. However, the small diameter of the micro-grinding tool has limited its machining performance and efficiency. In order to solve the above problems, micro-structure has been applied on the micro-grinding tool. A morphology modeling has been established in this study to characterize the surface of micro-structured micro-grinding tool, and the grinding performance of micro-structured micro-grinding tool has been analyzed through undeformed chip thickness, abrasive edge width, and effective distance between abrasives. Then deviation analysis, path optimization and parameter optimization of microchannel array precision grinding have been finished to improve processing quality and efficiency, and the deflection angle has the most obvious effects on the rectangular slot depth, micro-structured micro-grinding tool could reduce 10% surface roughness and 20% grinding force compared to original micro-grinding tool. Finally, the microchannel array has been machined with a size deviation of 2 μm and surface roughness of 0.2 μm.

References

【1】
【1】
 
 
Chinese Journal of Aeronautics

{{item.num}}

Comments on this article

Go to comment

< Back to all reports

Review Status: {{reviewData.commendedNum}} Commended , {{reviewData.revisionRequiredNum}} Revision Required , {{reviewData.notCommendedNum}} Not Commended Under Peer Review

Review Comment

Close
Close
Cite this article:
JIA J, ZHANG Q, YANG W, et al. Analysis and optimization of microchannel array precision grinding processes with micro-structured micro-grinding tool. Chinese Journal of Aeronautics, 2025, 38(7). https://doi.org/10.1016/j.cja.2024.09.037

2

Views

0

Crossref

0

Web of Science

0

Scopus

0

CSCD

Received: 13 June 2024
Revised: 25 July 2024
Accepted: 02 September 2024
Published: 30 September 2024
© 2024 Chinese Society of Aeronautics and Astronautics.

This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).